Frage von Andi1972:
Hello,
voted in favor of Canon XH A1 an external Micro receive. The Beyerdynamic MCE 72 cam. An XLR cable with 2 XLR connectors. 1 with the red marker to the 2 stands, one with its yellow on the 4 stands. What must now while times and what do I need to adjust the Camera?
I'm totally confused and the scant instructions in the manual to help me, unfortunately, is not next.
Can someone help me?
Thank you very much
Andi
Antwort von Markus:
What time must now where ...? Normally, stereo connectors for the rule
"R ight ot =
R, the other times left".
The details of Beyer dynamics is at the microphone of a cable XLR (5-pol.) On a 3.5 mm stereo jack here. Is that when your Microphone differently?
Antwort von Andi1972:
Yes for me it's different. There is an XLR cable with 2 XLR connectors for the camera here.
When a camera is called the CH1 other CH 2 ?!?!?!?!
Hmmmhmhmhm
Andi
Antwort von mikroguenni:
Moin,
Lt. Data is left of the pin 2 and pin 4 of the right channel. That's true not with the colors (red = right) are identical.
Does the Microphone s.der for Camera?
Output unbalanced, capacitive decoupled
5-pin connector. XLR male
Pin 1 = Shield
Pin 2 = NF - links
Pin 3 = free
Pin 4 = NF - right
Pin 5 = free
Greeting Mikroguenni
Antwort von Andi1972:
Yes, the work already Mirco - times times depending on what I am and what I infect the numerous buttons so XLR Micro adjustment.
Unfortunately helps synonymous since the manual net next. It must be because something like ne very clear rule, just as the times then, of asking the button on it and the switch is in das ...
I would even a professional guide for the Camera to buy something like the book for Canon HV 20 But so was gibts ja for the XH A1 does not
Andi
Antwort von Schlafsack:
Hello Andi,
Just try it out. Dein Micro has a built in Battery yes, otherwise it would be indeed the "PV" model. Clasp it to an XLR on Channel 1 (left) and the other on channel 2 (right). then you switch to the Micro. Phantom (front desk: +48 V) off the A1 and the A1 now on. In the Audio Setup menu activate XLR, ie "to" choose (manual s.Page 44). About the XLR sockets of the A1 are four buttons: LINE / MIC switch to make MIC. The selector switch for input channel CH1 to CH2 are so right. The XLR MIC ATT switch to the right to "off" and the other on the A1 on the menu knöpchen the AUDIO LEVEL switch to "A" represent. Should fit to play.
Now you can next to your micro with the fingers snap and the display of A1 observed. If you left schnippst, the upper bar higher bud. When you snap on the right Page logically the lower bar. If it's now the other way around, then replace the XLR-Male to.
Gruß,
Rolf
Antwort von Andi1972:
Hello Rolf,
Thank you - as I had hoped for an answer :-)
Andi
