I hope I get as a new in this forum do not like scolding of each! Have been synonymous for my problem gegooglet and durchstöbert this forum, but found nothing suitable!
So, the following problem!
If I make a film about the media player or VLC player, etc. from the calculator on the Television chic, then the beam, are displayed on the monitor can be seen, not s.den Television sent. If hot, the picture is eaten (egg heads). Have something to read in the forum, but found no suitable answer. Previously, the synonymous everything went great, but for some time no longer. Have a 6600er than GT graphics card. Old movies that were previously correctly s.Television were presented, there are now no more! Can it with a driver related problem? Or I have an essential attitude perhaps forgotten. Can not be that you must convert any movie, or maybe?
I thank you in advance in advance for your help!
Dekkmate
Antwort von WoWu:
Hello Dekkmate
welcome to the forum. The black bars are not synonymous "s.den Television sent" as long as you are an anamorphic picture did exist as you describe. The transmission signal is a quasi-TV station, which signal you offer him and he "staucht" then click the Picture in the proper format. This signaling seems not to work. What output / input interface as you go into the TV and have something with the new GK changed?
Antwort von joerg:
I assume that your television supports only 4:3? Whether the source material is 16:9 or 4:3, here you have the aspect ratio set to 4:3 and then burn to DVD or a 4:3 television s.den send.
This error, I have past the starting material 16:9, and the DVD output as 16:9 aspect ratio and in the television set as egghead version. But in the PC, it was clean and no 16:9 egghead version. Then I have the 16:9 source material for the DVD output set to 4:3, here I finally had the black bars.
Starting material, which is 4:3, I have time on DVD in the 16:9 aspect ratio is created. To result in the Television (4:3) was left and the right of the black bars, but an eggshell head version, the PC was a clean 16:9 with black bars left and right.
Antwort von Dekkmate:
hello everybody!
First thanks for the reply until now. I hope I understand you correctly, wolfgang! do you mean, with what kind of plug into the TV set I go? So, I've s.der graka a round plug with RCA connection. in the TV set but I go with pure SCART (I hope you mean it).
another thing, if I use a normal dvd on dvd power play, then the beams above and below.
@ jörg: I want but not all FIME to burn dvd, synonymous as they are not so great for a whole dvd to fill. usually it is anyway avi files or mpeg's synonymous.
Antwort von WideScreen:
The problem is that the Media Player 16zu9 the material in place, the black bars will be in the full media player the picture just in the middle pushes. The black area above and below is actually not there. If you now the whole via FBAS of the graphics card to send the TV, then the television in the fullscreen without bar dar. graphics drivers take it not so accurate and so, so "komsiche" error. Operating times the resolution of your graphics card at 1280x720 or a value divided by the xxxx yyyy = 1.7777 is. Then it could go. If the player is running in the window, the aspect ratio should vote, huh?
Antwort von Dekkmate:
Hello everybody!
Thanks for the reply. Yes, if I have the player in windowed mode run, then run the thing. I'll soon be as well run, is not the most original solution, but the result fits yes. Thanks again for the answers.
