| Problem with convert
Question of Günter Lefi:
Oktober 2008
I cut my video with Premiere 6:02 and Exporting MPEG 2
inportiere in Imression DVD SE 2
My jerky video during playback.
Who can help me what settings I need to carry.
Please simple answer, I am a layman Beginners and bloody.
Thanks in advance
Günter
Reply opel:
When exporting to the best quality go mpeg2 jerky synonymous with me.
Although it cost more disk capacity, but the result is then synonymous accordingly.
Reply JMS Productions:
My jerky video during playback.
Define the times "bucking" accurate. Moreover, times where you describe your video judge. Jerky, if you s.Television anschaust or s.PC?
I've suspected something, what your "shakes" it might cause, namely a false Halbbildreihenfolge. To do this, but with 100% certainty to be able to say you need more information.
Reply Günter Lefi:
Thank you for your answer I will try to better describe it.
Original video is ok.
When you cut jerky is synonymous not only with the convert in Imbression.
What is the correct order of the fields, while recording in Prem. I first upper HB when converting Lower HB.
For an answer I would be very grateful.
Günter
Reply Günter Lefi:
Thanks for the reply.
How can I best Quallität Ein?
mfg
Günter
Reply JMS Productions:
What is the correct order of the fields, while recording in Prem. I first upper HB when converting Lower HB.
Well, when DV material would be lower field first (Bottom Field First) attached. As for me, but I for the first time a film had rausexportiert and burned to DVD, then has me terribly geruckelt all synonymous. Then I burn my films ALWAYS only with Upper field first (Top Field First) and everything is fine! Try out the times and reports, whether's he's successful :-)
Reply Günter Lefi:
Hello,
Thanks for the tip with the fields.
I have tried everything with the top half first,
or bottom field first, but without improvement.
Did you perhaps have another idea, there are s.was
could?
I used it when recording synonymous with the PC with the upper and
HB lower first attempt.
It always shakes when exporting to EMPG 2 FILES.
But with the same software already produced good results.
Thank you for your effort and I hope you can send me with a
good advice to help you again.
Günter mfg
| |
