Frage von Supe:
Hello Once again!
This time I'm looking for tips to a usable Aufsteckleuchte for my 1st XL It should be possible that it is both a battery works as synonymous with normal power supply.
In addition, they will naturally not be so horrendously expensive and give a sufficiently good point illumination (f. Persons / face). What's there to it? Who has good experience?
Thanks for your tips
Supe
Antwort von tvschaumburg:
So I would recommend due to the camera extremely light, chess is a minimum of 75 watts, rather 100Watt Lamp Manufacturer da gibts so different, I'm a bit more expensive, which I use in my present synonymous .. They are usually connected via XLR Male and adapter for gibts always synonymous.
If you do only indoor 75 watts is ok, but if you want to do outdoor shots are bigger than one person will equal 100 watts or very very close:)
Antwort von Supe:
Hi tvschaumburg!
I think synonymous 100 W should be.
Then let's hear what you have and can recommend. A normal XLR adapter, I have wide.
Thank you,
Supe
Antwort von tvschaumburg:
I have a Sachtler head light 75 watts and 100 watts Sachtler'm actually one of peace that has not dimmed, but can my Akkugurt if yours can not, I would recommend you a Sachtler head lights with dimmer ... price to my knowledge between 50-150 euro
Antwort von Markus:
Hello you two,
to 75 watts, I would send the Panthers into the race with Romy 75. But what is the price of 50 - 150 EUR concerns ... where to buy professional head lights (net? new?) for the price? Or how much you have to take so that you land at this price? ;-)
Why the Panther Romy 75?
I "
I had been working some time ago, also with head lights ... " Video Forum ->
Video Light Panther Romy 75 W
Antwort von MiXMaster:
Hello!
I have now opted for the 75 W light dimmer with gates and daylight filter (EUR 274). It is those days. I'm curious! Otherwise, I have two lights for photography, which I could use.
Best regards and many thanks for the advice!
Supe
Antwort von MiXMaster:
Hello!
Hardly the chic thing is there, to me raises the question: How do I connect this thing s.meine Camera. s.der is in fact an XLR adapter (three pin), another Panther Romy 75, however, solely a four-pole connectors. Bracuhe am I now an (other) adapter, and how do I get current to the lamp.
Thank you for a brief explanation!
Supe
Antwort von tvschaumburg:
hmm sorry but it Währe me a completely new one which supplies the head light on the XL1 with electricity, exactly for the reason there is a 4 pin synonymous tuned ...
Gibts network equipment for the times or have battery belts, just as you synonymous kannste battery belts for the simple purpose built yourself, but the camera itself will provide not have enough juice
Antwort von MiXMaster:
Hello tvschaumburg!
Ach menno! So one thing comes to others.
Also to the question: Can you recommend something?
Chief who has one Bastelanleitung for Akkugurt with XLR -4 times?
Thanks once again!
Supe
Antwort von Markus:
Hello,
on 4-pin. XLR connector and matching Batteries schau mal) in the thread
What light? (And subsequent posts.
I think that you win a good overview. ;-)
Antwort von prem:
Hi Mark!
So now I have a 4-cell Batteriegurt (PRB-18) of Bescor with a 4-pin XLR Adapters and Zigrattenanzünderhülse one-on-XLR4 adapter.
Although I bought a batch of synonymous Ansmann (BCA12-2, 12V = / 1.8A) and then soldered to pin 1 and 4, a XLR4-book, but somehow it does not load well, although the Cradle 'store displays' short-circuit and is.
Now I would need a similar charge, such as the Model Bescor BC-1000 (1A, 12V), but there's the somewhere in Germany? Or, here's someone who I can solder together a run against mite? Then please report.
Thank you!
Supe
Antwort von Markus:
What do you still missing is a meter for voltage and amperage. Then you can fact check that all connections are properly soldered, if the charger is working properly and whether the battery is properly charged.
Thus, a device called the most multi-meters and be had for a few euros.
Antwort von prem:
Hello Mark!
Oh, I've always synonymous and gucke. Connections are properly soldered. Did I even soldered together as a unit with a matching connector itself. It shows synonymous Voltage 13.1 V). Unfortunately, the battery seems to take anything because the synonymous shows after hours o, at 1 V. Warm it will not synonymous. Very strange. # Let's see if I can still manage it.
Seuftz!
Supe
Antwort von Markus:
0.1 volts? Then the case is clear: The battery is gone! No battery in a discharged state has such a low voltage.
Antwort von gnoi:
After several days of the shop now pulls himself slowly to the Battery. One cell to the other takes up power. Cell 1: 5V, cell 2: 3V, Cell 3: 1E, cell 4: 0.5 V.
How are they running it? In series, parallel? Parallel but would actually make more sense, right? The same current, high stability.
Let's see how it works.
Supe
Antwort von Markus:
If it is your battery in a Pb-battery, each cell has 3 volts, resulting in series 12 volts. Since Pb Batteries s.preiswertesten and simultaneously have higher current, they will be happy as an energy not only) for head lights (used.
However, you such a deep discharged battery will most likely no longer regenerate. Even if the voltage should eventually vote again, so after charging the battery will only have a very short period of use. This then is in no way commensurate with the load times.
BTW: What is the head light (brand) You've really got to you?
Antwort von gianca:
Hello Mark!
Once again typical Ebay-Schmu. The thing to load any more. Crap, but you do with learning. For 300 purchases for the first time a bad experience. Is just bad luck. I will still run minimize losses through the sale of the belt as
broken on ebay. Maybe someone needs something else for yourself.
Now I have the same part of Adorama ordered from the U.S. (including shipping $ 200), for further German Manufacturer except Panther (675 EUR on demand, although LMWH) or Anton Bauer (720 EUR, synonymous NMH)'s probably not exist. Much less of the values here are not synonymous. The P-part is only slightly more compact and burns 0.4 hours longer.
I have now taken the Panther Romy 75, but due to electricity shortage, I was able to test yet.
I thank you for the postal support and enlightenment!
I report next.
Supe
Antwort von Markus:
A lead-gel battery for 35 euros it had originally done, perhaps synonymous ...
Antwort von Diego:
Had asked where to get it. But he know anybody. As I said, I'm thankful for every tip that :-)
Supe
Antwort von steve:
done
Antwort von prem:
Lead:
www.reichelt.de
or slightly more expensive
www.conrad.de
Antwort von Supe:
Thus, the belt of Andorama is finally here. And it does, both the belt as synonymous light. Booyah!
Leisure still a new cigarette lighter socket tinkering to XLR-4-times, but it is now, when I'm in the soldering exercise. Now, there is still a surprise if the Assmann-synonymous to Battery Charger 12V loads, because the supplied Bescor BC is 1000 indeed a 110V-Charger, which we therefore can not be readily used in D-Land (switcher has'S) none.
Thanks again for the help and expert support!
Supe
Antwort von Markus:
If you have several 110V devices, it might even be worth a voltage converter? I have such an American for my model railroad. ;-)
The cigarette lighter clutch You can completely synonymous for a 4-pin. XLR exchange coupling, rather than dazwischenzuhängen an adapter. Then this rickety motor vehicle fall-away connection. (Why build some battery belt Manufacturer something?)
