Frage von joce:
Hi,
Viedeodatei (AVCHD) from the Project window into the source monitor pulled in .and outpoint set, then to insert or superimpose button adds just the video or just the video overlay. The audio track does not come with the cutting window.
I am avoiding the source monitor and drag the clip directly from the project window into the editing window, everything is ok.
But you can monitor the source so beautiful and pre-pointed, I would not like to want.
Do you advice?
Thanks Dieter
Antwort von Wiro:
Hello,
it is because you in the track header (on the left in the timeline) the corresponding track is not activated it. There are various possibilities. Just click a trial a bit in the track head and watch what happens.
Greeting Wiro
Antwort von joce:
Nee, Wiro isses nicht.Hatte unfortunately synonymous already rummprobiert.
If I were with the mouse, so I put in. and outpoint in the source window, then drag with the mouse from the source window to the window, I cut only the selected area and it may be just an average window of your choice position, with sound. Is it synonymous with life, but to insert a comma and "point" for overlap was synonymous not bad.
Gruß Dieter
Antwort von Wiro:
Hello again,
the method I / O / comma works completely correctly (for me).
By selecting the buttons V A1 and the far left in the timeline, you can accurately determine in which track the clip when you press the comma is stored. Try again in tranquility. I work very easily with it.
Greeting Wiro
Antwort von Jörg:
the method I / O / comma works completely correctly (for me). right click in the track header-> assign source, ditto in the audio track, it ensured that the traces are activated.
Antwort von joce:
Yes, but there was still something overlooked. That's So
Thank you very much right.
Dieter
Antwort von Wiro:
right click in the track header-> assign source Even you can save.
The buttons V and A1 can be with the li. Comfortable mouse in the desired track and enable / disable.
When "Just cut 'is normally always the trace 1. Interestingly, this feature only if one works with trace mountains. Then flutscht it correctly ;-)
Greeting Wiro
