Frage von matthew:
Hello!
Do you know ne way to s.einen lower Walimex tripod car (not MA NEN Manfrotto 114 tripod car zb) s.die role, as well NEN cable locks can be affixed, or whether it sowas überhaupt to buy there?
Or maybe there are extra rolls so that Kabelstoppern with such equipment, which you can then yes synonymous s.dem Walimex install it?
If both failed, how would you solve this problem so that the cable does not come under the wheels? (Except of course, NEN Battery to take lol):)
zum Bild Thanks for your help!
gruß matthew
Antwort von Platinum:
The roles are all weighing the same tripod. Since the left and right turn ne mother. I habs made so that I made of sheet metal such as cable locks, or how the hot've made, and then put these nuts hab. Pro du 2 rolls need such tin particles, the rivets you together, and then down nuts, sheet metal on it, nuts back up. When required in advance black paint and it is already done. Material costs about 3 euros, about ne Shears, NEN drills and a Nietmaschiene. And a pair of pliers for bending ...
Schöne Grüße,
Robbie
Antwort von matthew:
I can ask them to send visual NEN ichs so I can better imagine? thank you!
matthew08 [at] lycos.de
Antwort von rtzbild:
Kuckstu:
3 x sheet length:
((Wheel diameter x 2) + (Width x Wheel 2) + 20mm + 10mm overlap
Width: 20mm
6 x sheet length:
3 / 4 diameter.
Width: approx 20mm
The three sheet bend so that you begin as follows:
10mm, then 90 ° tilt.
+ 5mm + 5mm wheel width, then 90 ° tilt.
+ 5mm + 5mm diameter, then 90 ° tilt.
5mm wheel width + + 5 mm, then 90 ° tilt.
+ 5mm + 5mm diameter, then cut off.
Now you have to three approximately 20-mm wide rectangular frame, where all sides (l, r, o, u) 5mm Wheel is the place.
The framework solder, glue, or otherwise mechanically latching inextricably close.
In the six small sheet "keeper" holes drilled, so that around the hole or at least 5mm space.
Deburred edges, corners off.
Two sheet metal strip "keeper" vertical left and right s.Dollyrad label.
Frame drum, small sheet metal strip "keeper" to the inside.
Under the framework of approximately 3mm Square uprising on the surface (floor, table ,...) leave.
Position of the frame holder s.Halter on checkbox and again by the keeper Dollyrad removed.
Frame operator as above and solder, glue, or otherwise mechanically latching inextricably together.
Below on the balance sheet to remove.
Deburred edge.
The whole on the other bracket and frame transfer and similar procedures.
Workpieces paint at the airport, at least protect against corrosion, paint dry.
Complete and attach Kabelabweisersystem s.Dolly me 3 bottles of good Riesling Spätlese sweet send.
Good luck!
LG Olli
