Frage von neamt:
Hello!
Question has ever someone has a dv-camera open (cut) had?
The basic question is that I ride enduro and around the whole world for which you hold me I've a helmet camera (Sonyccd 520linien) which I bought on the av-96e in s.meiner sony connect, but the whole very complicated because I'm also a battery pack for the helmet camera and microlocal consumption and then lance, a total very cumbersome and it comes with a kabelsalat ...
Now my thought about ne cheap dv camera zb. sony hc27 and buy the camera module from the housing to take on a cordless and operate, now represents to me the wonder is this possible? The photo-digi cams, it is usually so that the camera module is not fixed with the board is ..., or is it electro technically possible, in relation to the cable length of about 75cm the cam module from the rest of the electronics abzusetzten?
I know everything now sounds quite confusing, but I did the whole market which helmet camera solutions are also searched and found the abgeshen of the solution which I've used (which is very cumbersome) enweder only solutions are either inadequate quality of supply or just priceless for my purposes (eg mpeg2 flash recorder, priced ¬ s.1700 ...)
thanks for the help
neamt
Antwort von Bernd E.:
... camera module from the housing to take on a cordless and operate ... I remember very dark, that it take a camcorder has of the house could only reminds me of the best will no longer be a manufacturer of what it was.
Gruß Bernd E.
Antwort von maus1208:
Uh, complicated thing.
It is possible, theoretically. But theoretically, it is synonymous possible to fly to Mars.
Problems:
- Lack of shielding. at low signal levels at 70cm distance to unacceptable quality nem waste come.
- The parts are highly integrated. Nix with "da camera module, since Rekoderteil".
The whole mechanics like auto focus, the lens system are an integral part of the housing. Will there really hardly rausbekommen.
But I do not know where your improvements should be.
Whether you now NEN camcorder in my backpack and searched NEN cable to its external camera or whether you prefer the camera module and rausfrickelst NEN cable recorder part to draw in my eyes comes to the same thing.
Only that the probability that you have a camera then they split and still works extremely low.
or just priceless for my purposes (eg mpeg2 flash recorder, priced ¬ s.1700 ...) Where hast thou compatriots?
I have a friend of only positive about this device belongs Chen:
Antwort von neamt:
Hello!
thank you for your reply!
That part makes ORIGON yes now no good wircklich videos: "verpixelung (mpeg4), blurring in fast movements and also very sensitive to bright dark checkered bad (at higher speeds not available) ton times apart!
Well, the advantage would be that I am only a maximum of 2 cables from the rucksack hab, 1 for the camera and 1 for the recording is also the battery pack (for helmet camera and micro) and the micro and off accordingly kabelsalat, quite apart from the times that if it is possible, with a much improved picture quality may be expected because the analog to digital conversion and eliminated the transmission of the helmet camera to dv in the present variant via RCA cables are not necessarily synonymous for quality speaks!
I know only of photo-digi-cams where the real image chip, optics and the autofocus or zoom history 1 kommplettes part is, I just suspect, but do not know that at the synonymous dv cameras will be no different!
I think that with the shielding should not be the problem should be with a high quality cable can solve the basic question is rather whether the already written up as a complete module, or whether when the cam opens the optik "falls apart"
I am very clear when the requirement with the "separate camer mode" gegebenwäre despite everything still lots bastellei accrues to the whole in a reasonable form to (aluminum housing for camera module, housing and corresponding control buttons for the remaining part recorders)
Thank you
neamt
Antwort von neamt:
... camera module from the housing to take on a cordless and operate ...
I remember very dark, that it take a camcorder has of the house could only reminds me of the best will no longer be a manufacturer of what it was.
Gruß Bernd E. That was the samsung miniket or so had an external camera module is the problem s.dem thing is that as mentioned already written back only s.to digitally and is the external mudul of quality is fairly low (sensitivity to light, TV lines )!
A similar variant of Aiptek's synonymous but drops out in another thread discussed up of home-made flat!
Thank you
neamt
Antwort von maus1208:
"I know only of photo-digi-cams where the real image chip, optics and the autofocus or zoom history 1 kommplettes part is, I just suspect, but do not know that at the dv-synonymous cameras will be no different! " If not otherwise synonymous camcorders, lens and sensor is usually a unit, even when the FX1 that someone disassembled and documented on the Internet has an interchangeable lens installed.
However, I would rather one of today is already very light DV cameras on the whole helmet mounted (as in TV forerunners in ski sometimes be seen) and by Catcheye II Lanc remote to operate. Shutter release button is double adhesive tape to attach s.Helm and the LED control is just under the edge of a helmet in sight.
Apart from this would be a totally rigid connection of the camera with the handlebars or even better with the motorcycle frame anyway the better solution, because a calmer picture in the video would be seen as in a camera on the "shaky head", which is still about the practical driving synonymous times to the right or left turn must.
Antwort von neamt:
Hello!
So the camera s.lenker or elsewhere s.moppet to befestiegen garnicht goes, because 1 has no image stabilizer weld this with the vibration 1zyl a motorcycle and 2 deal with the mechanics of the camera is not nice long, I doubt even a camera round the i survived!
Sorry but the enduro (fahr I run), everything is designed for lightweight, hab extra 150 ¬ more for my helmet so that the output to weigh 1000g (standard 1200-1300g) comes true I do not ask me 400g (that's then eh light-weight) on the helmet buckle, synonymous if they have not displayed much in the whole "gehopse" then drag the s.genick quite nice, quite agesehen that it is often fairly closely with branches and the same and the camera sooner or later something would be destroyed! The quietest bild gibts experience according s.helm, of the above problems with vibrations times ageshen würds the montage s.moppet purely technical perspectives have no sense that the route are not like the formula 1 always nice flat with "big" curve radii because offt 180grad gehts ums eck at a radius of 1-2 meters or synonymous times of the straight-up with 100% pitch, or down, as would be consistent with the results will not be beneficial if the camera is not the view of the driver is!
Here is a video Kleiser example, the "murky" is s.staub, the flicker s.einer bad cable connection, was the first to use the kammera therefore looks a bit too far "in the ground" ...
Antwort von maus1208:
Well, thought not that you're real enduro rider. The shocks keep a single course, no camcorder, which is clear.
The BMW "Enduros" on the street would headless Shooting is more work.
Generally, but not really rigid attachment to the parallel movements Fahbahn a problem synonymous and not a real task for the Image Stabilization, but rather the pitch movements at the start and brakes, etc.
