Frage von ralfc:
Preface: For years while I work slowly, but smoothly, on a
XP Calculator with 1.8 GHz with a dedicated Firewire card, various versions
Of Video de Luxe, and two Sony cameras, TRV50E and FX1E (only in DV mode).
For the new year, I allowed myself a special offer of Packard Bell, with
4 cores, 6 GB RAM, Win7/64 and Firewire onboard. In addition, I will
synonymous upgraded to video ProX, and in fact the world would now be Ordung
must be short tests with the FX1, VPX and recording via the onboard
Interface functioned smoothly.
Now it was s.das first film project with the FX1: appeared in the preview window
Recording on the first minutes after 2 colorful blocks, which are sometimes increased.
After 2 to 3 maneuvers showed the preview window after the start of play
only a black or white picture, every now and then turns to the
Restart the playback (the Rangierbefehle still rattled, Picture no longer).
Is it s.der Camera? To verify this (and get the film into the Calculator to)
has now been connected TRV50E: no reaction, in spite of different reset operations
s.Calculator and Camera (s). To observe is only a brief display of DV-Connection
on the TRV50 monitor when you plug the cable, but the connection is to
2 seconds away again - every time ..
As a fallback solution was to remove the previous PC: replug the cable on, and wonder --
no reaction! So far both have been cameras on the calculator when plugging the
started right program, now comes in manual startup to note that the
Connect to the device could not be found) (for each of the cameras. Of course
synonymous times the cable replaced without result.
Then an alternative test: About DV in SonyDVD hard disks in the recorder, here the film was
easily see from the FX1E too. Next test: Fujitsu / Siemens laptop with 1394 port.
The FX1 is not reporting at all, the TRV50 shows peculiar: The reference to a
existing computer port "" flashes, 2 seconds, we all, he appears briefly and then goes
under slightly flickering screen (like a reset) immediately off again.
Both cameras are now broken?
If the on-board cuts of the new machine, the DV input from both cameras shot?
Can such a damaged camera input from the previously reliable machine for years
schrotten?
Is there a way to test the functionality of the cams in a different way (DV-in
s.Festplattenrecorder is only half the battle to hire ..?).
I do not advise me in the moment more - someone has a tip, or even
concrete experience with it?
Already, many thanks,
Best regards, Ralf
Antwort von deti:
... maybe your firewire cable is defective.
Deti
