Frage von B.DeKid:
Hi @ all times because I had a question about the syncronen recording devices with the Canon XL 1s and HHB PDR 1000th
I want my XL with the DAT and then connect via the Time Code syncrone shots to make.
The Canon has XLR ne shoulder support, I have several un Sennheiser Mics are available. I am concerned with the connection to the Cam Dat, so I when I start the recording (on cam) of the DAT mitläuft.
The DAT has obviously synonymous Timecode XLR connectors.
Generally
- Is it or not?
- Which cable is used?
- Can the XL1S the Timecode s.das HHB PDR 1000 further indicate?
DAT have separated the whole time of the coupled Cam never used (usually an additional sound recording device, or use the Cam Motion capture often for matters where no sound was used)
I would thank you very helpful suggestions and answers.
For HHB, it has at any case the function to time code control system that is synonymous in the manual described, but unfortunately I have no plan how to use both devices coupled together.
Alla I hope there are few foxes NEN among you tip NEN me want to give thanks.
MfG
B. DeKid
Antwort von Bernd E.:
... Can the XL1S Code ... Time pass? With Canon's I know is not at all, but as far as I know, the XL-H1, the only one that can output time code. The XL1S would surprise me if it would go. If a possibility exists, but it should be mentioned in his instructions.
Gruß Bernd E.
Antwort von RupertGr8:
To view the time code of a Camera s.ein other device needs to be able to send it has a TC-OUT, which is mostly as a BNC-Male is executed. Soeinen the XL1S as far as I refer to the specifications grad could not.
