Frage von Simo:
hallöchen
I have a small problem. I have a inenraumhalterung for my car so I just built the inside of film can be (racetrack, etc.). However, the car is probably too loud and when I film, I have an extreme "Knatterton", as if holding the frequency is too low.
if my firewire card decides to return with the camera at times, I will tolerate a little video to upload, but I hope you can you imagine what I mean.
what can I do, gibts ne hidden setting somewhere or have people with a tip?
Antwort von WoWu:
Hi Simo
... according to the description does it really after a clipping, although I do not only to the deep tones would relate. Attempt but once an external (dynamic) microphone because the sound for pressures up to about 105 db and designed so that should be excluded Micro .... if this is not enough, and your input is overdriven amplifier, a small attenuator between Male and Camera. In the grip of Krige is all male.
It can of course be synonymous, that knocks over the camera mount will be transferred (noise), it would be with an external Micro synonymous around the world faster than you would a (damped) holder must build.
Antwort von Simo:
it is definitely s.der volume. I have back in the exhaust as a "plug" of the karre rel. quietly but nat. synonymous performance swallows. if I understand correctly, the drive go out and I am synonymous over 105dB (at least outside). I have a ding in it, the shots perfect. I draussen these corrosive Knatterton.
then I think I'll use an external micro, wo gibts die? :)
Antwort von WoWu:
.... for the application reaches a really good part ... perhaps someone can tell you from the forum a good source to say ...
But I think that is how it works.
Antwort von Frank B.:
The XM 1 has not a man. Tonaussteuerung but the way the mic. Level mitigate. Already tested?
Frank
Antwort von Schleichmichel:
That will benefit nothing. The low frequencies must be capped before something is changed. Complete the level runterzusetzen's no use, since even the upper spectrum of the deep, unnecessary and far too strong frequencies are completely distorted (popular error, incidentally).
Antwort von Frank B.:
That will benefit nothing. The low frequencies must be capped before something is changed. Complete the level runterzusetzen's no use, since even the upper spectrum of the deep, unnecessary and far too strong frequencies are completely distorted (popular error, incidentally). Hm, I would have tried it anyway times. Perhaps that is synonymous to Windcut an alternative circuit. The would be synonymous but the frequency response severely prune. When it comes with an external mic does not work, it could be synonymous with a fully external audio recording thought.
Frank
Antwort von robin1990:
The XM 1 has not a man. Tonaussteuerung but the way the mic. Level mitigate. Already tested?
Frank no not yet, where can I find the option?
would be nice if I get a link to a cheap (need the mic just for this one purpose) mikrofon had previously hab ma rumgegoogelt but found nothing really.
Antwort von Schleichmichel:
Unless something between Microphone and microphone input for a reduction s.den low frequencies makes you is not the synonymous help. You are in a deep bellowing car. There have been a small-EB sound mixing her. And then go off ...
Antwort von stefanph:
So now I have a cheap pc microphone drangehängt (I only thought I have no small jack port but only above the port fürn mic) and now it works. the sound is not intoxicating, but it does not knattert and you hear everything so far.
So problem solved;)
