Frage von Gast:
Urgent: On the first day of the week, turning a Canon XM2 adopted.
What happened? External rotation - that is around 0 degrees. Only a few minutes, easily used, transported then 5-10 minutes in hand, set back five minutes, then goodbye to the Battery.
Problem now: After changing the battery the following phenomenon that is synonymous for a twelve-hour period of rest indoors and did not eliminate battery changing. The display will be just fine red and white vertical stripes appear. In addition, the Camera asked when you first turn of the new appointment date and time. Problem is on display viewfinder and the same. When I press record, to include the strip. Watch and coils can be the tape that is yet.
Is disturbed, the image chip? Can reset the part, perhaps, total factory state? Instructions defect site I'm grateful for any help!
fs
Antwort von Maik:
In addition, the Camera asked when you first turn of the new appointment date and time. This points to an empty backup battery. Usually a small lithium battery
CR2032, etc. which is hidden somewhere behind a small door (I know
The XM2 is not as accurate). I would replace the first time and see what happens then ...
M.
Antwort von Gast:
At the Battery, it is unfortunately not. I've tried it with nem exchange. The dealer mumbled foolishly of something "never seen" and "logic board".
I'm still none the wiser. On Monday, the part goes into the repair, if not previously nor does a miracle.
Gruss,
fs
Antwort von MiXMaster:
Supplement your neck and reading:
Motherboard was replaced, now she is running.
What it was, knew the Vertragswerkstatt not synonymous.
fs
