Frage von RawBurner:
Hello folks!
I'm already s.verzweifeln have searched all the forums, but no solution for my problem.
My burner (both TEAC) is always hang up when I try to burn with Nero. It always happens sporadically at times 15% times 50%. Anyway, not a single burned DVD to the end. CDs to work properly. There are all types of DVDs (ISO, video) is not burned.
Since I now have a burner replaced and now have a flammneuen, I tried out of three burners, and all depend on at some point. So I can exclude the devices.
I burn now alternatively with Ashampoo Burning Studio, where every fifth synonymous here with the DVD burn hangs. With CloneDVD I have a similar problem that most DVDs are burned but s.and to the burner hangs.
Now to the details: hang with, I think that the status bar stops, but time is running next and all are responsive program. So the calculator does not depend on that burning program itself is still responsive synonymous, it is not "no feedback" in the Taskmanager. The burner will run next, but for all eternity, I can only reset the calculator.
I already have the latest chipset drivers installed (nForce4 on Gigabyte K8N Pro SLI) and it has not helped. I have been synonymous versions of Nero tried, of 6.6 to the latest that you can download at the moment. The burners have the latest firmware synonymous receive gifts, which brought no improvement synonymous.
I have Win XP SP2, AMD Athlon 64 X2 Dual, 2GB RAM, Samsung IDE disk and a Samsung SATA disk, gigabytes GraKa.
Has anyone any idea what this can be? I do not know exactly what I did back then, when it started. At the beginning I Case synonymous not much attention until I somehow did 10 blanks verschossen.
I'm grateful for any help, I really do not know next.
PS: would like very reluctant to switch to other Brennprogs if the proposal now, I will try WinOnCD or CDRWIN.
MfG
Alex
Antwort von Markus:
Hi Alex,
You do not accidentally use the cheapest of all Noname-firing blanks for your attempts? There is a lot of garbage (= committee) in the process of such problems.
Antwort von RawBurner:
Hi!
So I've finally on the junk purchased Verbatim blanks. Of course I know that not everywhere where it is verbatim, it is synonymous Verbatim. But I would not be synonymous with other burning programs have problems?
Blanks so I can already rule out, because I of extra friends who have tried and especially Brenne I have been a backup and movies on DVD-RWs, which always have worked and are now synonymous. This fact gives me the certainty that it is not s.den may be blanks.
MfG
Alex
Antwort von Markus:
But I would not be synonymous with other burning programs have problems? That is however an argument. Spontaneous synonymous otherwise I would have no idea if it is UN-BE-related! Nero should remain ...
Antwort von steveb:
1. What is it with the heat genrellen development?
2. Defective cable (idekabel) or not properly steckend, bent pin or something similar?
3. Incorrect jumpers the burner master / slave?
Of course, one of these causes are not just "logical", because CDs will work, but it must s.irgendetwas is yes ...
Antwort von RawBurner:
Hello!
1) The heat I've pretty well under control, the burners have a free slot above and below, I have also released WaKü
2) IDE cables I have ausgetuscht, pins are synonymous okay because I thought that synonymous.
3) Master / Slave is correct, otherwise the board would indeed one of whom do not recognize.
Other suggestions?
MfG
Antwort von steveb:
One of the times the burner in another PC tested?
