Infoseite // DVD Players, Television and Cable



Frage von matratzki:


Hello,

for me is the following problem for a customer ... we should a bakery equipped with a TV.
On Television is connected to a DVD player on which a film is playing in the loop. And the cable connection, or receiver, running on the NTV.

Every few minutes (10-20) is now the DVD player and the receiver to be and her (auto).
I have absolutely no idea how to achieve this aim.
Are there timers for such a thing?
For most TVs so the signal is switched to auto, when a DVD player is eigeschaltet.
However, this is just in standby mode and needs of manually.

Have an idea for her to get out?

Image mixer was an idea (too expensive) or any device, what is for such purposes at a monitoring company could get?

As I said ... I have no idea ... please help me

Space


Antwort von Markus:

"matratzki" wrote: ... or any device, what is for such purposes at a monitoring company could get?
Sounds understandable, but as a forum for videographers and less (!) For the video surveillance specialists, should the discussion be not too busy.

Try it out for surveillance technology forums or better yet to find surveillance video.

Space


Antwort von Quadruplex:

"matratzki" wrote: Every few minutes (10-20) is now the DVD player and the receiver to be and her (auto).
I have absolutely no idea how to achieve this aim.

If it is a standard television that you can search for an adaptive remote control looking for a timer in it, or with a bit of electronics and 'nem suitable infrared transmitter sowas even tinker with (or can tinker).

Space


Antwort von thos-berlin:

What does it with a manipulation of the scart control signal from?

ME is connected s.Scart source, if a switching voltage of 12 V is applied to the operation of video equipment signals.

If the tension is gone (as the device as a signal is turned off, then back to TV. So you would need only a circuit which is in the required intervals to control line breaks (possibly via relays).

Whether the approach is OK, you could have a look with a SCART cable to check, where the switching contact with a rocker switch is interrupted.

If we could pass on the search for a switch for low voltages or entsprechdne Kits

Your question is, however, whether the 6zeitgesteuerte jump into a current or a current Fil television is so great.

Space





slashCAM nutzt Cookies zur Optimierung des Angebots, auch Cookies Dritter. Die Speicherung von Cookies kann in den Browsereinstellungen unterbunden werden. Mehr Informationen erhalten Sie in unserer Datenschutzerklärung. Mehr Infos Verstanden!
RSS Suche YouTube Facebook Twitter slashCAM-Slash