Frage von Colo:
Since I have been recently on a new calculator with a large cut monitor, I notice several errors much more clearly than before.
I now noticed that some HD video clips, before rendering completely without fault, after the rendering of the project to start for a brief moment falter, not always, but quite often.
Since I use the MPEG-Optimization using the original recording settings are used, so that the clip itself is not new anymore rendered, which is synonymous in the previous display, this is inexplicable to me.
When I use these clips in a critical short test-Project cuts together, the problem does not occur, rendering the whole film (only 24 minutes) though.
I'm pretty clueless! What is this phenomenon? Greeting Colo.
Antwort von Sektionschef:
I think it is because a known bug which is synonymous in VS12 is not yet properly resolved, see this thread at the Ulead forum:
http://phpbb.ulead.com.tw/EN/viewtopic.php?p=175196&sid=298d2d2e74e70464553bb47e2d555f73#175196
Obviously there is a patch to VS12, but does not seem to work and so it is still synonymous provides Ruckler.
I think where synonymous have read that there is a difference is whether AVCHD or HDV material is used. For HDV it will help the MPEG Optimizer disable (no smart rendering), with AVCHD is seemingly no solution to eliminate the Ruckler.
mfg
Section Head
Antwort von Colo:
Thanks for your answer. Through trial and error, I am now on a similar approach has come.
First, I examined the error in the project settings and in the preferences, then I guess the reason for the change machine, etc. The idea that the cause may be in the best render setting, in the MPEG-Optimization, can lie, I would not dream of come. Since I have only been recently used, is to me this phenomenon is not noticed until now synonymous.
In any event, I am now at a new trial does not render the optimization is used, but the button and this project setting changed. Instead of constant 25000 (corresponding to the record setting!) 25000 variable. Unbelievable but true: The deadlock at the start of the clip has disappeared.
With logic has nothing to do!? Finally, one should assume that clips that-as in the MPEG-Optimization re-rendered not be synonymous in the finished film, the original play behavior should be. As always synonymous, I'm glad a solution has been found to have, especially for my combined VS Still Image / movie shows a practical program interface.
The fact that this bug still exist, is more than annoying!
Again thanks for your help. Interestingly I find the synonymous link to the Corel Forum, which I often times in the future contact will be. Greeting Colo.
Antwort von Colo:
Did some tests and found that:
No motion lag s.Anfang the clip
1. at variable bit rate video with SmartRender
2. at a constant bit rate video without SmartRender (even with MPEG-Optimization)
Perhaps this tip is synonymous for other help. Greeting Colo.
