Frage von KrischanDO:
Hi,
in the experiments, the sound recordings of the radio link with s.der EX-1 to optimize, I lost myself among the many places where you can adjust current settings in brackets:
At the receiver of the radio link: Sensitivity 0 dB to - 30 dB (- 10)
In the menu of the EX-1: Set audio / audio input / TRIM -11 dBu to - 47 dBu (-41 dBu)
On the Level-wheel outside: at "5" is the level in normal language against -10 in the display of the EX-1, with minimal overruns.
In these settings, I am with voice recordings are not satisfied, it sounds scratchy. Both speakers with professional as synonymous with a sometimes noisy handball coach. Micro a few fingers wide on the lower end of sternum.
Over a few tips I would be delighted!
Regards
Christian
Where gan
Antwort von Natevi:
Hello Christian,
I suspect that you have the output level of the receiver set too high, because there are some stages (AF out). I use 0 for Sen. s.Sender, - 6 AF out, turn on the audio input and mic control in the middle range for the input s.der Cam.
Antwort von KrischanDO:
Hi,
Tomorrow I will test times. Thank you!
Christian
Antwort von KrischanDO:
Moin,
have just a little rumgetestet:
Setup: Ansteckmikro between 2nd and 3rd Hemdenknopf (or anatomically: a hand's breadth above the line between the nipples),
Sensitivity s.Sender: __00
AF out s.Empfänger: _-06
Audio in Trim EX-1 :____- 29
Levelrad :____________ 5
Monitor Level: Mid
Speakers: Sennheiser HD-25 CII
Thus do I get in normal speech in a subdued room halfway Level -10 to get at Lutes conscious explosives ( "P!") S.Sender yellow PEAK diode.
The sound is full, only when I turn on the monitor level, I hear the noise.
What I do not understand: In the TRIM menu of Sony Will it be louder rauschig and if I find more Cons-dbu - values go.
Sound will remain a weak point, because all of above 10.000 Hz against a subtle tinnitus must prevail. :-(
I test next ...
(Always write down everything beautifully, from 5 Einstellstelloptionen)
Christian
