Frage von Berntromp:
Hi Folks,
I have one newly introduced to my EX3 Fujinon Xs8x4-Stop Wide AngleObjektiv, which is synonymous to tender for the EX-3.
Now I have the problem of the long shots in the Picture looks very muddy, this experience has anyone else done?
Antwort von tommyb:
That means you ran zooms to provide sharp, zoom to wide-angle and it is blurred?
If the lens of a lever with which you can set the back flange?
Antwort von ed-media:
I see the back flange is not true when the problem occurs as described.
Antwort von robbie:
Stern siemens download, Flange set, and off you go;)
Antwort von Berntromp:
OK, maybe I should write about this that I should recalibrate before each change of the flange-optics.
Respectively. the EX-3 makes it so the camera itself might have to be really just keep those 3 yards to the Siemens star? I do not know ...
Antwort von ed-media:
In the EX3, there are very automated Auflagemaßeinstellen, as I read the manual times.
"... Ok, maybe I should write about this that I should recalibrate before each change of the flange-optics. ..."
Normally you do not provide the back flange before the lenses, but only after the lenses, which brings it otherwise?
It would stop the joke before, and then switch on the lens!
Antwort von tommyb:
And then you have to adjust the flange-never again - except the meantime Lens Camera s.einer other was.
Or is set in the back flange of the EX3 CAMERA s.DER directly and NOT s.Lens?
Antwort von WoWu:
To adjust the back flange, one must
adjust the
FB function and use the Lens of itself is calibrated
However, there has been some trouble with the old software, so that the PM is not really true.
Maybe the synonymous because the picture is blurred, because I am assuming that you had set the back flange.
Check out the firmware version, if it still should be blurred.
Antwort von Berntromp:
sorry have devoted myself, ... I backfocus add the course after the new lenses!
And Thanks Wolfgang, this helps me ... next!
Antwort von robbie:
I guess the automatic adjustment of the support level works only with the EX-3 Lens.
Have you ever had a manual setting with a Siemens star itself out?
