Frage von Alex.A:
Hello,
The title already sounds confusing, but ..
meant is the following:
1. HDV recording in HD on capturing Calculator
2. HDV material to DV runterkovertieren
3. In AP3 Project HDV and then create the DV material cut
4. The link to disconnect from DV and HDV to re-establish
5. Export as HDV
I have this approach as heard rumors and would like to know if there is truth or what it s.einem points (probably point 4) would fail?
Thanks and greetings
Alex
Antwort von PowerMac:
The permanent conversion of HDV to DV, the time to make everything yourself again, time and order effects in the film to re-render HDV - much longer than if you cut directly in HD. Offline editing is a relic of the 90s. When new batches are also happy to fail.
Your proceedings, but it brings little. It takes longer and ruining your camcorder.
Antwort von Stallforce:
I think you mean the traditional off-line editing. Of course go to a cut in DV or less and to simulate the patch list in HDV "abfeiern" to leave, if your NLE then connected to the VTR or camcorder can access. The relevant parts of the tape are then encoded in HDV and the product is created.
Antwort von Alex.A:
good to know ... Thanks for the info.
I forgot to mention that I use the whole material only 1 time from your camcorder and would like to capture in one pass, ie 1 large media files. Then runterkonvertieren and not converted naturally leave because I want to eventually cut the use and effects ...
But apparently, the None of you so oda? If so, why a short feedback and therefore, it is better yet, would be very helpful.
Gruss
Alex
Antwort von PowerMac:
Then you can cut synonymous normal and just 25% in playback quality editing program setting. And only s.Schluss render.
Antwort von Alex.A:
... da haste synonymous right again;)
