Frage von maxpayne_cid:
Have only just completed a bought HV20 and it's somewhat annoying to me, of what I'm not accustomed to Canon, noticed.
When I in the snow (it was cold!) Wanted to film, had the record button on the display only geblickt. I had no Selbsauslöser configured. In any case it went to 5sek it really filmed. But that was already too late. It happened only one time. Was it the cold?
Weis someone what that was?
Antwort von Markus:
It happened only one time. Was it the cold? If the error does not make it, probably the cause remains speculative.
Antwort von maxpayne_cid:
Yes. I think synonymous. Nobody else had the problem?
Antwort von maxpayne_cid:
thus. scho is happening again. It was at night and very cold. I think it is real because of the kaellte. Canon has here, of that which to me, a few problems.
Antwort von darg:
Small intermediate question. Do you have the Camera eingeschlatet and immediately after you have a picture on the display had the record button is pressed? Then you get always a blink. This makes the HV20 and HV10 always, if no preference in the fridge or in the sauna, which is holding a long starting time. Perhaps, you were just a little too fast for the camera. For me, however, the first 5 seconds, despite the flashes on the tape on it. The Camera buffered by the relatively well.
Gruss
Axel, San Jose
Antwort von Fantomas:
So I was the week with my skifahrn hv 20 and there were no problems with the cam, even when they had to eat properly schnee
was at minus 5 degrees, sometimes even synonymous with minus 15 so there should be less subject to cold s.der
