I'd like to use my Humax 5400Z mitmein computer IRCI connect the cable and so I have already connected but he finds it not, perhaps I need a special program for this?
What do you want to achieve with the connection? Channel list editing? New firmware,?
What kind of cable it is, and where you have it on the receiver side and computer-connected?
You must have write precisely what your goal is.
Antwort von Sammy1989:
I want to connect through the channel list to edit. I have a: "0 MODEM" cable. I have s.Calculator and s.Receiver connected, but there is still no connection, because I do not know how I should proceed next.
Antwort von beiti:
Serial connections are not Plug and Play-compatible like USB. So if you have something s.den serial port connects the calculator does not remember of themselves, that there is something new. But you must not synonymous unsubscribe if you want to pull cables.
You have to stop in the station program lists the correct COM port (usually is COM1; search on all 4 if necessary), and then the transfer would work. The software you should see if they are not at the receiver was on the
Antwort von StefanS:
This info is likely to find on the HP of Humax. I was already close, but I would have to register and log them. Since I can not have a Humax synonymous was too lazy to do, since you have probably even read.
