Frage von Interlaced_Killer:
Hello!
I've long been an External Microphone s.meinem camcorder is in use, you can attach the s.der 3.5 mm jack. The mic itself is screwed flash s.einem angle mounted.
The problem is that there are clearly audible at the slightest touch of the cable knocking sounds. The closer s.Microphone, the louder, but synonymous in contact s.letzten end of the 3 m extension cable s.Kameraende still clearly audible.
(Even without contact, by mere camera motion, and thereby) cable movement, it comes to knocking noise!
Well, my questions:
1.) Let minimize the knocking sounds by some special coating?
2.) Are there external Aufsteckmikrophone have the connector cable, which are resistant to the touch noise?
I'm synonymous willing to invest a little, but the sound should be followed properly and the handling is not too complicated.
Antwort von Lutz Dieckmann:
Hi,
You're using an XLR cable? No? Should you. Sound on automatic? Should not you. This could be the reasons.
Regards
Lutz Dieckmann
Antwort von tommyb:
If the phenomenon has only recently been on or ever?
Most likely, it is s.einer loose jack or even sooner (s.einem defective cables, broken cable).
To find out where the cable is broken, you have to hold the cable so that as little movement is going to come. Then you wobble out s.Kabel and her.
