Frage von matthias321:
I have the Lego Technic follow focus solution cobbled together and tested s.der GH2.
Standard 14-140s on the construction unfortunately leads to the fact that s.einer office lacks the contact pressure and can run the operation of the focus wheel into the void.
I'm currently working on a solution.
The defect can be removed from under
illustrate.
The parts list I've compiled below http://saxmachine.de/2010/12/diy-follow-focus-lego-technic-with-panasonic-gh2/.
Antwort von B.DeKid:
Cool
.................
As this needs to solve the prob?
Nen Cage build? or only NEN DämpferRad which you can go to Page flaps?
MfG
B. DeKid
Antwort von matthias321:
As you can see in the video, so be missing s.der place s.der the transmission (yes, that is the Lego titles;) is located), even a wheel to build up the pressure.
At this point, but that can be easily installed none since then too far in the direction of the camera housing projects, to zoom remains possible (using a fixed focal so this is not a problem).
I watch now know if I based on the existing Lego parts in there work a can, which is mounted next removed, or whether one simply cuts a tire and the attached to the gear (the nice lady from the Nuremberg Lego "flagship store" has given me even have a tire :-)).
Antwort von B.DeKid:
Yes, the test can sometimes think the craft itself.
Otherwise one would have to stop tinkering NEN cage which s.Ort FollowFocus and the place holds.
MfG
B. DeKid
