Frage von buzzard:
Hello!
I have about 2.5 years old with my MV600 image recently interference. I refer to almost exclusively in the LP mode.
When I record on the same cassette again (sample means) interference will not occur. (Ie If the tape - though already two years old and not broken -? Is the video head derfekt or dirty? Can you clean the self, etc. ..)
Please see brief look at the screenshots:
****
1)
zum Bild shows a type of interference occurs only kruzfristig, then a few seconds, and only once or twice per hour recording
****
2)
zum Bild Shows the different type of disturbances occurring throughout approximately one third of the volume (with a few interruptions)
****
3)
zum Bild the accurate recording of looks ...
*****
So thank you for any information
lg, buzzard
Antwort von Markus:
Hello,
This picture does not look for typical problems, digital tape or recording errors made. I rather bet on a problem with the image intensifier or signal processing. However, I am a mystery, why the errors disappear when using a cleaning cartridge.
Maybe you can check the time a professional.
PS: You still captures hopefully not with 1024 × 576 pixels? ;-)
Antwort von Acer:
When you capture in the LP mode, it does not surprise me. The cassettes are much more susceptible to aberrations, because 50% more space on the tape is made available - Now we can guess at whose expense is based, correct: the picture quality and its aberrations;.)
Take better in SP mode, since you have "only" 60 min. or 80min. (on a long tape) place, but there is enough to risk any image imperfections.
Ciao,
Philipp
Antwort von buzzard:
Hello!
Only again, thanks for the promte answers.
ad1)
Reinigungscasette? No, I have so far not been used ... But if I s.der body of the tape where the picture noise, again HOST, there will not occur Bildstörunen. (Hab quasi verify whether the tape may be wrinkled or so ...)
ad2) to LP Well, I can not do without. I have this picture noise, but only recently become synonymous. (However, I almost always use the same tapes ... - and therefore the question of the Ordinary wear and tear of the tape, the video heads, etc. .. So what, it could be your opinion.
lg, buzzard
Antwort von Markus:
Perhaps you once citations in this direction:
"
Probleme with Bildausfall beim CCD Sensor? "
Sony Camcorder with faulty CCDs in circulation If you still have warranty, I would claim the device in any case!
Antwort von Acer:
ad2) to LP Well, I can not do without. Why?;.)
Antwort von buzzard:
Thanks for the links wg. defective CCD sensor - but find no evidence for Canon ... And even if - warranty has expired.
Why I do not want to give up LP? As you see I use the Cam often take our gigs (for their own "control") - and the durations more than an hour per set. Painfully enough to change the tape in the pause - (first time from Dismantling the Tripod, etc. ..)
Well - unfortunately, no one has yet found of our gigs takes charge .... It must mean "Urlaubscam" firmly mounted on a tripod serve them.
...
but I am still not become a smart, whether it's my cam over, I will get me only new tapes, or to buy time, a Reinigungscasette, etc. ..? (Sure, I'll try it all times - just thought someone was to start with the screenshots ...)
lg, buzzard
Antwort von Woody:
Hi!
On my MV600 I have the same problem - all black. This is a defective CCD image sensor. Canon replaces this sensor synonymous after the warranty has expired.
Enclosed official text of CANON https: / / self-service.canon-europe.com/at/pages /
Thank you for using one of our Canon products.
With rare exceptions, it was found that the video output of some CCD image sensors used in digital cameras and DV camcorders of Canon, are not working properly.
We regret that this may have caused inconvenience to our customers. Canon will offer free repairs where an error is caused by this malfunction.
Canon would like to apologize and refer you to the problem details and the recommended approach in this regard.
Problem details:
It was confirmed that in individuals, in the affected products CCD image sensors used in extremely rare cases, high temperatures and high humidity, the internal wiring comes off.
If this defect occurs, the signal is not in the correct shooting mode output of the CCD image sensors. This can occur Bildabnormalitäten listed below:
Images are not displayed
Image colors are not displayed correctly
Images appear distorted
These symptoms can be reviewed s.LCD monitor.
Solution:
We ask all customers that are experiencing their cameras, the symptoms above, contact s.eine Canon Treaty workshop.
The repair will be performed free of charge if it can be confirmed that the internal CCD image sensor wiring has been resolved.
LG - Woody
Antwort von buzzard:
Hello!
Can only confirm. Actually, I must apologize - after all, I brought my camera shortly after my post to Canon (after expiry of warranty) and that have changed the sensor / chip and charge without hesitation.
Although it is another mistake unbehoben left behind (if not shut Picture s.Schwenkmonitor) but these are probably normal wear and tear s.Flachkabel which is always in motion.
All in all, I am still very happy with the camera which is now 4 years old (in use since 2003) and provides good service.
lg, buzzard
