Frage von Sven:
Hello,
gradually I despair ...
SonyDCR-HC32E, firewire card, AMD Sempron2400 +, 512MB RAM, WinXP with SP2.
I now have most all the programs through which I've found here in the forum and elsewhere, WINDV, DVIO, sclive20051228g, Movie Maker, pinnacle, ULead Video Studio and a few more.
Time after capturing the picture is pixelated and grainy, sometimes streaky. Yet I have still not at or similar to MPEG compressed, drawn only absorbed directly (as DV-AVI) and as an *. avi on the hard drive.
Herumprobiert had previously been without SP2, since only synonymous poor results. Have the wedding of my brother-in with the (new) camera filmed, but if you are already hard at avi does recognize the faces, I just need to make garkeine DVD out of it.
Who can help? Thank you!
Sven
Antwort von Jan:
It really can only s.den capture settings are, we now need for all programs probably make an analysis. I am surprised only that notice of all programs, the same effect?
LG
January
Antwort von VolkerS:
Hello,
should normally occur during capture any loss because it is imm principle only a copy from the tape to the hard drive. Have you seen the movies schonmal right of the camera to the TV, as there is the quality?
When it during the shooting of the wedding in the room was not very bright, it could be that the original material is already noisy.
Antwort von grovel:
This is precisely the quality which is on the camera. 1:1
Apart from simply s.PC worse than s.Television.
If you have cut the Project simply transfer to the camera, or burn to DVD and watch again s.Television.
SeeYa grovel
Antwort von Markus:
Apart from simply s.PC worse than s.Television. ->
Problems with the quality after reading ;-)
