Frage von schloegel-edv:
Hello,
I have Studio 10.8.0 SE. Windows is re-attached.
The system runs for s.and easily. But if I burn the finished movie will turn off the PC after about 10min from the right. Without warning. And always s.der place where the frames are written (frame of xxxx yyyy), so not yet in the writing process. Pinnacle says I should be the scene where this happens rausnehmen in AVI, and re-integrate. I can not imagine that the solution should be. I do more on hardware. Has anyone ever had similar?
Is a Gigabyte motherboard and an Athlon X2 5000 Processor with 2 GB of RAM
Thanks for info
Rüdiger
Antwort von Kunterbunt:
I would try with the. Avi make.
There is a long-unused Note that better blocks with about 10 minutes and single length geraendert are assembled, and several of these building blocks later on the film zusammengestezt be!
That is a possibility that the errors that many clips and many effects on a large project can make to circumvent, or at least isolate.
How long is the Project?
Antwort von Daigoro:
Remote: Could be a heat problem?
"Write frame" means in the case of "rendering"? Since the CPU usage is consistently high. These high temperatures in the moment. The hardware is aging stuff is so synonymous with the time sensitive. It is composed of dust from the Kuehlerleistung adversely affected.
At the motherboard should be a tool to be that the temperature (Processor / environment) reads.
Let the times at render (or with Prime) run and look to see how the temperature behaves (maximum for Athlon64 x2 should be about 65 degrees core temperature - less better).
