Frage von Udo:
I mentioned above, video camera and program and finally want to archive my movies. The program, however, does not recognize my camera. It always takes place again that I ought to connect the camera display on or off. About the Device Control menu item I've tried it already. Also does not work.
Who can help?
Antwort von coconut:
As the camera is connected?
Via firewire?
Antwort von Markus:
Which operating system?
What service packs?
Antwort von Udo:
As the camera is connected?
Via firewire? Camera is connected via Firewire. Camera, cable and connector are onHabe tested it on a buddy with my Camera and cable. He has the same program, and since it runs.
Gruß Udo
Antwort von Udo:
Which operating system?
What service packs? Windows XP operating system, service packs, sorry no idea. Camera and cable are onHabe tested it with a buddy. And because it runs. But he has windows 2000th I think it is s.Betriebssystem.
Gruß Udo
Antwort von coconut:
I'm thinking You're lying right.
Win XP with SP2 is the Firewire - absolutely killer ...
My XP is "naked" and it funzt all is well.
Antwort von Markus:
Windows XP operating system, service packs, sorry no idea. Start> Control Panel> Performance and Maintenance> System.
Antwort von Udo:
Hi Mark,
've checked, Service Pack 2
Gruß Udo
Antwort von Markus:
In this case, you will help the post
Antwort von prem:
Hi Mark,
Help was on your contributions, the link with the patch does not work, then have a roundabout way to the Mircosoft Page and I have a patch downloaded. It still does not work. How can the SP2 of runterschmeißen my calculator.
Gruß Udo
Antwort von Markus:
Start> Control Panel> Software> "Windows XP Service Pack 2"> Select click Remove.
The last two steps are advised because I only have SP1 on my XP computers. Since then, logically, is synonymous only "Windows XP Service Pack 1" in the list. ;-)
Antwort von IngoK:
Moin!
However, if you have a new XP with SP2 using, it is not in the software list. Since then helps only the purchase / replacement of an older install CD. With a simple "install this one again" it is not done, incidentally. Also, the manual exchange of some drivers did not help.
Therefore, I have a new partition with a separate XP SP1 established. Thus, the material is then brought to the PC. Editing and burning, I then take care with the XP SP2. This path is not as elegant, but I did not want to lose all my settings and installations.
Gruß Ingo
