Frage von Stefanpinnacle:
Hello!
So the following .. and its predecessor Onnacle know quite well! Now I've done made a movie at Studio 10, everything has worked out great .. only if I'm going now to create on film (Whether disc ect, File.) is the green bar under the preview window of blue on and running .. (So this "I work", it shows) .. But that's it been synonymous. The file will be written (as usually around 5 KB), but otherwise I can wait until tomorrow and nothing happens next. CPU utilization synonymous nothing .. the old 9th anything you have seen live, has worked where the .. now what do I do now. I want to cut again unwillingly absoult everything because it's available in the Pinnacle 10 and can be synonymous to watch .. only the movie creation fails! .. HIILLFFEE! Thanks
Antwort von Voltz:
In S10 you can the undocumented keyboard shortcut CTRL + SHIFT + POS1 use (at least 3 seconds hold). This will open a small window with which you can follow the rendering progress.
As far as this time.
Have you installed the latest patch 10.1.1 and 10.1.2 (for AMD processors)?
If this does not help, then your project times divided into several smaller sections. This was true for earlier versions of Studio always been considered the "golden rule". Moreover, you will need to re-edit anything, but hopefully it will find the place s.der ausbeisst to S10 teeth.
Antwort von Bass_bernd:
I am synonymous already happened: Pinnacle have "free access to the Internet" has (that Pinnacle must be enabled in the firewall and the like for accessing the internet). It is ostensibly no data s.das Internet, but the program needs access to any file on the system.
I have completely given my Zone Alarm to access, then hat's synonymous with geklapptt rendering.
Antwort von Voltz:
Where did you get that here, Bass_bernd?
Studio needs definitely no Internet access.
Antwort von Voltz:
Addendum There is a FAQ of this Pinnacle:
Studio does not require an Internet connection. Studio need only be able to Rm.exe by the TCP / IP protocol copiers. Your personal firewall software may under certain circumstances, however, show that attempts Studio gain access to the Internet, but this is not the case is.
Most Programs firewall (Zone Alarm, Norton Internet Securiy, ECT), a message will show and ask if the program has permission to access the Internet. With Studio, you must confirm this message with Yes, it can communicate with the studio Rm.exe. Studio does not go completely off the internet.
You can verify this by running the cable to your DSL or cable modem of removing your PC. "
Antwort von Kujo:
Have the same problem (version 10.7). When creating a DVD or DVD image of simply doing nothing. Avi or mpeg goes against it.
Antwort von Andreas_Kiel:
Hi,
had a similar problem that can output 1080i resolutions, does not go, but 720i and 720p. Is s.der graphics card, which has only 128 MB. Perhaps it is similar with you?
BG
Andreas
Antwort von Hollgo:
DVD creation has nothing to do with the creation of s.sich MPEGs with a Resolutiongrößer than 720p to.
It is, in fact, that it is better 256 MB on the JSA should be available so that the output in Resolutionfunktioniert MPEGs higher. This is not the ultimate reason for exclusion.
You can even try the program 3D views checker that is in the amount of S10 here.
The question that opens in conjunction with DVD authoring in S10, which is what material was used.
Moreover it is noted that the DVD production in S10 is unfortunately synonymous bugbehaftet and will remain as it now is S11 and is to be assumed that here again pushed in a patch for S10.
