Frage von Onkel Benz:
Hi,
just the hardware, so there are issues not to be made.
Gigabyte EX58 UD7 - i7 950 CPU - 12GB Ram - XFX 470GTX - SSD system disk with Windows 7 64bit.
Sun .. Now to the problem.
In my Project I cut mainly 1920x1080 DVCProHD P2 footage (MXF), which runs all synonymous and super smooth.
But now I have a graphical mask that I put over the cut clip. This mask was created with Compustion. It consists of 500 single images (TIFF), which I imported as "Numbered Stills". In the mask is a synonymous Keyed surface, otherwise I'd need so not the mask. I now play in the timeline s.ener anywhere, it runs for 3 seconds without problems, then there is always more jerky, up to 5 to 2 frames per second. Premiere is therefore with the homemade mask is not clear from Tiffs. What do you think of a format as the most effective for a mask? The mask should contain a Keyed surface and are the size of 1920x1080.
Or I can even play off the mask as a clip and convert me?
LG
Uncle Benz
Antwort von Jörg:
Or I can even play off the mask as a clip and convert me? That would be my advice, synonymous CS5 still has some problems with frames, or sequences thereof.
Do you have the update runs at 5:03, I have the impression that it's running a little better.
Think of the export s.den alpha channel.
Antwort von Onkel Benz:
Thanks for the quick reply
5.0.3 on it to, so synonymous is really much better, just over the Tiff-frame sequences, it is not as good or better.
Alpha Channel ... when you export from After Effects tells me something, but not really in Premiere.
If I are the "Tiff clip in the timeline and have had marked and will then play off as P2, where I alternate because the alpha channel?
LG
Uncle Benz
Antwort von Jörg:
If I are the "Tiff clip in the timeline and have had marked and will then play off as P2, where I alternate because the alpha channel? I know of no way to export P2 with Alpha support.
I use this app from the Lagarith, select the codec settings RGBA, or, reluctantly, QT Animation, here are the select 32 b.
Antwort von Onkel Benz:
Have the codec installed, you can not find the but when I click on Export-media ... go.
Specifically, it is not listed.
've Installed the "Lagarith_1320"
LG
Uncle Benz
Antwort von Jörg:
Select Microsoft avi, then down to video codec, you'll see the rollout of the Lagarith, choose the codec setting in the RGBA mode.
Set the parameters as needed
That's it.
btw
jerky to render it synonymous with the sequence of TIFF?
Antwort von Onkel Benz:
I thank you a thousand times.
'm Going to try some settings.
LG
Uncle Benz
