Frage von sebastian83:
I can not, unfortunately, my film back to the camcorder, SonyPD170 to spend.
The capturing is working properly, and according to manual is synonymous DV - In s.der Camera available. Similarly, there is that the camera to record on the VCR must be provided.
I will now start in the first function "on tape issue," starts the camcorder while recording the car, it is synonymous a red dot (= Recording ...) on the LCD display, but otherwise there is only a blue screen and not the actual movie to see. Similarly, the auto re-recording is not stopped, but running for so long next, until I stop it manual. If I then later the tape on the camera reflected, only a gray Picture shown without sound.
What could all this be? Thank you in advance ever.
Antwort von sebastian83:
If I were with the Windows Movie Maker trying to tape the movie to run, starts the camera while recording (again, without a picture), but the Movie Maker displays the following error message:
"The film was not fully recorded on tape. The DV device is not responding. Pull the connector out, plug it back into the socket, and then start the wizard again to save a movie."
Can this error synonymous with a higher firewire cable be circumvented? I use only the cable that goes with the Firewire PCMCIA card has been supplied. This does however Capuring flawlessly, without any image loss, synonymous device control works perfectly.
Antwort von Markus:
Hi Sebastian,
if the picture from the timeline, not the way to the camcorder will then check it out if the audio in Premiere - / video output port on the DV (IEEE1394) is disabled.
... according to manual is synonymous DV - In s.der Camera available. Similarly, there is that the camera to record on the VCR must be provided. Both are correct.
Can this error synonymous with a higher firewire cable be circumvented? The forecast would be pure speculation, but against a high quality Firewire cable never speaks something (see synonymous
Punkt 2). Im Zweifelsfalle versuche doch mal eine DV -AVI-File mittels
WinDV
Antwort von sebastian83:
Hello,
Thanks for the tip with WinDV. Thus does the computer for recording from the camera with the AVI file that I exported from Premiere did, flawlessly. As far as I have understood correctly, the export from premiere to the AVI file synonymous without any loss of quality? File size is just under 5 GB and the recording length about 23 minutes.
So when I finished the recording of the premiere of AVI file and execute them via the Camera WinDV transfer should be this way but probably the same quality as the direct "Export to tape" out of Premiere.
I'm just wondering why this does not work with Premiere. The capturing is running flawlessly, and the camera begins to export these cars synonymous with the recording, but unfortunately is not sound nor picture, but only gray color.
Antwort von robbie:
perhaps it is a particular problem in connection with the 170 occurs.
About the sources of error can only speculate.
You can, however, the settings in Premiere verify. When recording windows F5 you can put in the settings the camera exactly synonymous specify.
Hast thou before outputting to tape everything rendered?
Antwort von Markus:
As far as I have understood correctly, the export from premiere to the AVI file synonymous without any loss of quality? Usually yes, unless there is a bad (obsolete) DV codec used, but which nowadays is rather unlikely. And if in doubt, you could a few shots with the original version dealt.
