Frage von kathy:
Hi,
The question had already been found in slashcam often, but never with an appropriate response.
My problem: I want a MiniDV tape (on which it is to host a timecode rest) with Premiere Pro. Because of the timecode resets to the tape I've been thinking to cope without the batch list, but just the whole tape record s.einem piece. Whether with or without points: After recording a few seconds it always breaks s.and premiere brings me a popup and want to save the clip and gives me the error message: "Time Code not found during recording.
Please help me quickly. Thanks !!!!!!
Antwort von Wiro:
Hello,
obvious solution:
cue the tape about 10 seconds versuchs next and then again. Then it should work.
Gruss Wiro
Antwort von kathy:
Thank you.
Unfortunately, no.
I have already tried in the place s.verschiedenen band. the error occurs again and again ...
help! what to do?
Antwort von Michel666:
Well, if you have the opportunity to:
nimm nen hours camcorder or VTR and do ne ne 1:1 copy of the MiniDV tape via Firewire.
If the "original" tape, despite TC error is played properly, it `s works s.Besten. The camcorder is recording the TC yes rewritten, and you've got the same material without loss of quality with reasonable TC present.
Did I just yesterday must synonymous wiedermachen ...
Antwort von Pingo53:
Hi,
The question had already been found in slashcam often, but never with an appropriate response.
My problem: I want a MiniDV tape (on which it is to host a timecode rest) with Premiere Pro. Because of the timecode resets to the tape I've been thinking to cope without the batch list, but just the whole tape record s.einem piece. Whether with or without points: After recording a few seconds it always breaks s.and premiere brings me a popup and want to save the clip and gives me the error message: "Time Code not found during recording.
Please help me quickly. Thanks !!!!!! Hi,
the problem on capture with premiere pro ver 7.0 was synonymous, when I received dv-of want to take my canon xha1. no preference, ask s.welcher I start, there are two or three seconds of the announcement: time code during recording could not be found. the adobe support says I should in front of the camera recording the date and enter time (of course I made) and the scene detection off (does not work anyway). premiere works at 6.5.
Who can help.
Regards
