Frage von stanley:
Hi together,
I work for a long time s.mehr or less large video projects. When editing system I have Adobe Premiere Pro 1.5.
Now I have abschmiert often the problem is the premiere or just the whole Calculator lame sets. My main problem is not this but that after it cut my Matrox card is no longer recognized, so I synonymous as the preview monitor can no longer use. This is only the case in those projects that are already lubricated, but not where there are the steadfast.
When I was a "damaged" will open initially Project comes this error message:
"The Matrox realtime plug-in could not start. Make sure that you have closed any program that uses your Matrox system, then starting Adobe Premiere Pro, again"
otherwise everything's going great.
What can be and how can I fix it?
Thanks
Regards Stanley
Antwort von Bruno Peter:
Sounds so after a Treiberprpblem with the Matrox card.
If the card on a solo-IRQ?
In this direction, check please!
P-Pro 1.5 is lubricated with me before.
Antwort von Stanley:
yes ... Situated on a solo-IRQ
Antwort von Stanley:
I should reinstall the drivers?
Antwort von Jörg:
Hi Stanley,
of the message you described, I had, in a somewhat different wording
For years even with the RT 2000th Treiberneuinstallation had never done something. That was a reason to exchange them for Matrox Canopus.
Gruß Jörg
Antwort von Stanley:
yes that would be determined as a solution but can not synonymous do differently what? Namely, do not necessarily want to buy ne new capture card
Antwort von Markus:
Hi Stanley,
I work synonymous with the real-time video card Matrox RT.X100. So far, I heard little or nothing about any error (except when someone does not s.The compatibility list has kept). The system is running and running ... And very rarely (maybe) three times a year I have described to you of the error. Is not So next tragedy.
I noticed, however, that the system responds more critical than others Calculator on new software. In particular, the permanent install, try and uninstall of software makes the Calculator to create.
To try out a new software and can still always a working system to have, I have worked s.with beginning of an image program. When I install new software and then nothing works (!), I started later, the last known good image - and three minutes, the world is right again.
Now comes the obligatory question, to which my reply is usually a "No": Do you have a working image, which you can replay?
Antwort von Stanley:
Hi Mark,
You're right, I have recently installed a great deal of attention and her. If I had an image of the program would be great of course but unfortunately you're right with your assumption. Would it bring something to reinstall the program or would have catastrophic consequences for my project files?
Thanks Regards Stanley
Antwort von Markus:
Hi Stanley,
if you do this properly, this has no consequences for your project files (they are not on drive c :??). It will be missing perhaps the individual settings and fonts that you have optimized collected over time and.
However, the installation of a computer with real-time video card to keep a real challenge (just s.The order in the instructions!). Perhaps you
first create an image or at least some of the current and ongoing system ...!?
Antwort von WeiZen:
Moin,
trial and error I have two partitions with the boot manager, even an XP for testing, a current. Does the testing system no longer, it will be razed by Image and soon goes next. The synonymous lasts for 10 GB only brief 10 minutes.
