Frage von bjelgorod:
Hello dear Forum
I present to spark Sennheiser ew 100 with ME2 Micro in use in combination with Canon XH-A1.
I think the Micro is a little too bassy, and is due to the omnidirectional on it too much atmosphere in noisy environments with. Partial hear the sound of something synonymous overridden or cracking, although the level is within the normal range. Good for the Sennheiser ME4 what? It has a cardioid pattern, or has someone else do recommendations for an inexpensive alternative.
Thank you for your help
Antwort von deti:
Between ME2 and ME4 is not much difference - at least None that could be heard right away. When the speaker rotated away his head, then you will notice this when ME4 somewhat clearer. Frankly, however, is the extra charge out of all proportion to the result, unless you are bothered by s.knubbeligen clip microphone and head of the ME2.
Deti
Antwort von bjelgorod:
Hi Deti,
Thanks for the reply. You synonymous Uses the ew 100 spark gap? If so, I would be interested to know what level settings when you use transmitter and receiver. I had stopped at the station 0 and the recipient -10 and covered the rest of the camera, so it was not overridden.
Regards
Antwort von deti:
We have a lot of spark gaps in use - but usually somewhat higher versions.
In a normal scenario, you'd better sensitivity at the transmitter to-10dB. Thus, you avoid overloading on the radio link. Input If your camera has a 1.5 V line level, then you can "AF OUT Level s.Empfänger easy to +12 dB (for example, are fit for the PDW700 quite well when the manual audio control about half turned up.). Take in all cases, a closed headphones with swivel and to check the level on the ground.
If you still experience overload, then you can still go down the sender synonymous next - always disqualify better too little than too much!
Deti
Antwort von bjelgorod:
Thank Deti and nice evening
