Frage von Blaufux:
Moinmoin!
I'm with my Sony HDV FX1E a little problem:
I was always with the camera in DV mode, import video, no problem. Now I have recorded synonymous with the necessary plugins and SP2 to import HDV videos.
The problem is that although I can control the camera properly, and can import videos synonymous. BUT: The videos, which break up at first look very good, always after about 10 seconds into blocks. It is not practically possible to play videos in a length greater than 10 seconds on the plate.
What am I doing wrong? Is my calculator too slow?
Software: Premiere Pro 1.5
Calculator: Pentium 4, 2.6GHz, 512MB RAM, 200GB IDE disk.
Antwort von WeiZen:
Moin,
only one disk? So Windows and video files,'re already bad.
The capturing of the m2t transport streams should go. The Captuern and simultaneous conversion into an intermediate format even less. Without hardware I have tried only on a 3.06 GHz laptop also with only one plate, but with the software Edius. M2t stream When I was starting the virus yet. The Capture the Canopus HQ codec on the fly, when the real transformation of the original m2t format of the FX1 with simultaneous separation scene, was shut down cleanly with only virus scanner.
The FX1 is shown as a DVHS tape device.
Antwort von GhostDog:
Well, I have four slabs in the calculator, the two largest each 200G big. I've tried out the now synonymous everyone, without much success.
Synonymous, I think the transcoding will take place after the capture. Where could I change that?
Antwort von WeiZen:
Moin,
there are a contributing Of Wiro, maybe helps.
HDV with APP
