Frage von schwenkerfilm:
Hello!
When I film in a room that has a lamp and is switched on, throwing the long rays of light is always on the finished video.
Are there special filter, so I just like in real life, the light bulb and its brightness, but does not see the Rays?
Thank you,
Volker
Antwort von camtv:
Do you vertical in the Picture? This is the smear effect ,.... You have to live with. Or stop the light source can not put into the picture ....
Antwort von schwenkerfilm:
But in scenes, in the professional field, but is sowas never before. So it still needs to be avoided? Or?
Thank you.
Antwort von camtv:
Yes it would. what camera do you have? I recommend a Panasonic AJ D 910 WB or 900 sdx both with 3 x 1 / 2 FT or FIT chips ..... which are almost smearfrei. Or a Betacam 400 AP.
The smear is a typical problem that can occur in CCD through charge transfer. The better a CCD, the more expensive ....
Antwort von Axel:
like in real life Salut Volker,
If it can, depending on the camera motionless Objektivvergütung and light incidence angle, although come to reflexes (effect "lens flare", which will work in CGA-shooting, so they look more
like the real thing that works all the more true when it is seen through a camera) represents, but not to the
effect of
smear CamTV mentioned.
The light source is in Comparison to the environment is too bright, and this may not be on video. You could screw in a weaker bulb or turn off the aperture, but then the whole picture will be underexposed.
Therefore, there is a basic rule for recordings with video that can be violated only in a few exceptional cases (night in the
Big Brother container):
Always first provide basic brightness! That sounds terrible, according to a set of sterile artificial light. The course must be avoided at all costs. The basic light must be
spread very discreet and very strong, it is
not to
simulate the lighting of the lamp is visible in the picture, but only to avoid that this looks as if it had no living room lamp, but a plasma emitter phalanx. The light color should / should not therefore be the same. Living room, evening: We feel the faint night-light bulb for a more orange than slightly bluish. Just do not overdo it, otherwise it is kitschy. Mixed light situations require careful experimentation with the correct white balance. You are like from the cool ambient light, the lamp) red (Puff, you are like starting at the lamp, this nasty white in a sea of blue ice. A set of pastel-colored paper on which you have a "white can" make adjustment would be an inexpensive alternative to a conversion filter set. Tip: If skin tones are well taken, that is the sticking point. Also possible would be several light sources (visible justify) a stronger background brightness in the same light color to make.
This is called a procedure, the search for the Holy Grail, Film Look. The other is that the lamp can to
smear. Says: "Look, folks, this is
fucking video, and I do not care a shit!
The decision is yours. How
"in real life" we are guided in this medium
behind the light, all of the surrounding matrix, which works perfectly realistic () conservative approach, or of the rebels, who seem to have more chutzpah. But these are not synonymous only frayed sweater `ne mesh?
Antwort von camtv:
Axel which thou hast written well, but I think we are dealing with in this case, to smear. Your tip with the basic lighting so true synonymous here.
But how far should I go now to the technical with the answer? FT FIT, & c., has already dealt with a lot of good .....
