Frage von Auf Achse:
Hello!
I'd like to have experience to share about DIY Wind Fell s.alle interested.
For my Sennheiser ME 64 + 66 I cut a long time ago and it Webpelzkissen have ones for wind coat. In spite of which mounted Schaumstoffpopschutz I had the effect of only very modest.
Noticed it's me because I have fitted a few years ago for a trip through Patagonia (there's always the wind), my then small DIY wind Camera with fur. I have killed a stuffed lion (please forgive me dear lion) and its mane with glued tape over the small strip of double microphone openings. The effect was very satisfactory.
I investigated what's the difference in the lion's mane and the fur pillows and is found out that the lion's mane has a much higher fiber density (the hair length is about 15mm with about the same). If you hold the fur cushion material to the light you can see the holes in the ground tissue, it incorporated much less fiber than the mane.
... My search for a similarly dense fur in gray or black had given up and I bought for both mics finished dead cats. My assumption was confirmed, the fiber density is so dense as in the mane and the attenuation of wind noise at last very satisfactory.
My advice: If you have to thin fur damping power away! Furthermore, a foam must be under the skin to enlarge the still air volume.
Either sift through all the stores to buy exceptionally thick fur or something ready.
LG, on-axis
Antwort von crassmike:
But use it as a DIY "pop filter" Please open-cell foam as fine-pore filter foam from the aquarium. I got myself coming times as a 2cm thick plate filter foam, only to dampen even if the built-in camera microphone with wind can ...
To have effective self test can not yet - is yet to ... But with the onboard microphone of the small consumer cameras, so virtually unprotected sniff the wind, I expect, an improvement ...
To tinker with some fur, I have to find something even first convincing (and affordable), the glue is often used synonymous / and can pull off without rob apart ...
Cheers, Mike.
Antwort von Auf Achse:
DIY Workshop continuation ;-))
Another tip for the Consumer Cam: In the wind coat a piece of porous thin acoustic foam plastic, fix the whole thing together with thin strips of double adhesive tape s.der Camera.
As Unterlegschaumstoff s.besten suitable replacement foam ear cups of cheap headphones, which is about 2 - 3mm thick and suitable. Just the edge is put over the headphone speakers cut and cut to appropriate size.
LG, on-axis
