I hope I am mistaken, but it could be that you s.der Canon XL-H1 is not the Japanese (in mono) on channel 1 and the mixer via XLR to Channel 2 put it?
In order to maintain quality, I would only use 2 channels. These are synonymous in the menu set. In order anything from Mixer (XLR via Rear 2 / 4 connected), I have the Input Select switch to rear set. Then, however, is the Japanese tot
A solution is another advantage of microfinance as a Japanese, or someone knows a trick?
Regards, Juha
Antwort von robbie:
WTF is the Japanese?
Food for thought: The front / rear assignment looks like this: 1 / 3 and 2 / 4 are "together" If you are a Micro to 2 and one at 4 is the 4 lay in 2Kanalbetrieb dead Or I have to find your post somewhat misunderstood ?
If you channel 1 is on front and your Japanese? then followed, and the next on the Micro rear XLR input 2 (right) off you, everything is normal ok!
Antwort von Bernd E.:
"robbie" wrote:
WTF is the Japanese?
The built-in Camera Microphone.
Gruß Bernd E.
Antwort von r.p.television:
No, unfortunately this is not possible. Because once again overpaid engineer not properly considered. I always make an external Micro beside the camera on tripod. In just a shoulder operation ME66 or similar in the micro-holder of the Series microphones and plug into the rear XLRs connect.
I could not believe it is synonymous. Fortunately I have this camera with orders of this kind are rarely voted in favor and make my DSR-500, where something is self-evident.
