Frage von Andreas O.:
Hello,
at webcrawler.de (something different than how google ;-)) I always stumble back on this forum and hope now that someone can help me here please :-)
I have a positive test result above in the Magazine "Test and Purchase" (chip) the Yakumo Quick Stick DVB-T receiver purchased (USB port s.PC).
This works under Linux with a few handles and Kaffeine if the program had pretty good times, I get the north of Munich (city area at least) 19 PROGRAM immediately with clean, more or less good quality with the provided passive rod antenna.
So show me Kaffeine a signal of 18-22% and a SNR of approximately 90% (whatever that may mean these terms synonymous, here I am, unfortunately, still a layman and can complete most with) start calculating percentages somewhat.
So it would still be feasible to move the received signal or the SNR towards 100%, the only question is, how?
I've found by searching the Internet while already that you receive with the help of an amplifier or zwischengeschalten can increase with an active antenna, the only question is what is on my stick, which the power from the USB port covers, s . most appropriate?
I have read in this forum but already have a recommendation for "Technisat Stabantenne Digflex TT2" but running them without their own power supply. Enough to the USB jack of the supplied electricity?
Are there up to about 50, - EUR already usable for my purpose?
Thank you ever taken your answers.
Andreas
Antwort von Andreas O.:
Hello,
I have now gained the amplifier Skymaster Active DVB-T rod antenna with built-in, so now I get the strongest reception (signal 33%, SNR 93% among kaffeine).
Apparently my USB flash drive is compatible with active antennas do not have with its own power supply, such as synonymous already tried the OneForAll SV 9210 DVB-T flat antenna, which meant that each antenna and receiver "at war", immediately fell on the power signal 18% and SNR down below 85%, always sat well back from the reception.
The flat antenna hama sat down on radical addition inserted the power supply.
Conclusion: for me in the north of Munich is a passive antenna or an active antenna without its own power supply apparently s.besten suitable.
Now I have only one request s.The community:
Uses one can program in Linux and Kaffeine me the missing data on my missing channels ARD, arte Phoenix, plus1 MHP data service and say, especially the transport stream ID and the audio pid (s)?
The other data I have found already in the channels.conf the LinuxTV Wiki.
I get the automatic channel scan just purely Programs only 19 :-(
Andreas
