Frage von guru:
I'm sorry, I know it all many times before and you had like verweißt
here -new Firewire card (; pci ieee 1394 card)
-new Firewire cable
-My camera: sony handycam DCR-HC17E pal
-my computer: core2duo 3GHz, 3.25 gb ram, windows xp sp3 + (; this sp2 therefore have "patches" does not work)
capture-tries with: windows movie maker, windv, sony vegas7, ulead videostudio8
but I always get told that no camera is connected
is working properly capture with usb
which are still important for infos?
s.verzweifeln slowly I'm real, I am grateful for every little tip. or I should not go too slow times nem Fritzen computer?
as soon as possible if someone would devote themselves to my problem, I would be deeply grateful to him ...
Regards Tilman
Antwort von guru:
please help me?
Antwort von kaloku:
Is not exactly my specialty, but a further debugging option would aufjeden case, connect the camcorder time s.einen another computer - if the capturing with Firewire happening out there, you at least know that the firewire port works s.der Camera .. .
grüße, klaus
Antwort von david2:
It is synonymous with the old XP, new issue that once again on SP 3 are problems with the Firewire interface is. Could I understand synonymous. It should be fixed as under SP 1 can (but what will not work) - hab 'sorry, no time' s time for me to test.
Good times were really test it on another system / program.
Antwort von windows2020:
My Dv Camorder is no longer recognized synonymous of Premiere Elements (; PE) 2.0. Type Camcorder Panasonic NV GS27.
Have the same problem synonymous with Elements 7.0.
Camcorder is detected in Device Manager. About Windows Movie Maker, I can dub wonderful films.
PE reinstalled several times already - without success. OS Windows XP Prof. SP3. I have problem when I crashed a few days before PE, and I had to finish it on the task manager.
After each new installation the same PE says that the device is offline. Device is definitely online, as mentioned above. Who can help?
IEEE1394 interface.
Regards
Frank
Antwort von haenjuin:
Hello,
I have installed last week synonymous a new firewire card, my old had a VIA chip, the new a TI. With the old card I had no problems with my Canon HV20, the new card with TI chip, she was suddenly no longer recognized.
The solution: The TI-card uses its own drivers (; ubCore or something similar), the old windows of the enclosed.
Fortunately, the new card has delivered a program with which I can switch between the two drivers without restarting the calculator too. I switched the new card is now synonymous to the Windows Drivers ... And lo and behold, the HV20 is recognized again.
Maybe that helps someone.
Greeting
Marc
