Frage von wim-roegels:
Hi All,
I'm mainly just changed due to a very attractive because of the optional packs the power of software freebies for r.tx of Matrox.
So much synonymous with all very happy, but something very fundamental causes me a headache.
I have the feeling that the VIDEOOUT Appro of 151 corresponds to both the DV resolution than synonymous s.analogen output is not the full PAL, 1:1 or not the DV footage in the timeline.
therefore quite pure effects without a DV clip dragged into the timeline, and peeped gescrubbt cursor on the monitor.
I have the impression that it would be similar with a Picture, where you simply zusamenfuegt the lines, thus summarizing the fields to complete frames.
In my case the card is only a few hours in the calculator, maybe someone already has far-reaching experience with the device.
If I remember correctly, it confirmed to me synonymous a friend, would that be so in any case, the RT2500 was not then.
I'm thankful for every tip ...
Antwort von Markus:
I have the impression that it would be similar with a Picture, where you simply zusamenfuegt the lines, thus summarizing the fields to complete frames. Hello Wim,
would be a video card to spend two consecutive fields stubborn as a full screen while the cursor
is somewhere in the timeline, would be the picture on the preview monitor an eternal Gezitter.
Is that what you see on the video monitor?
Antwort von wim-roegels:
Thanks for your answer.
It is already clear to me that with the tremor.
Mir is fundamentally about the quality of the output .. I have only
compared the picture so synonymous with the state, "it would be like having", and do not mean that this is the problem.
I think the reduction in the quality but to be similar.
Here you get most of the little people RT.X ...
Antwort von Markus:
Well, I have for a long time, a RT.X100 in use. About the output quality, I absolutely can not complain. Is everything all right.
Antwort von wim-roegels:
I just finished my oh-so-young system again and re-fitted look ... seems to be OK.
Unfortunately I had to complain about the phenomenon that was the quality of the scrub, which is made smaller Performancegruenden yes, held synonymous with the forecast for the workspace via the ENTER '.
Now - after installation - is apparently all right ... synonymous I could not imagine that this is a fundamental problem.
Is there really a German Support Number? Have only one with 001 preset found, nothing else ... You nen Tipp .. if there should be something.
In any case, Thanks for your input!
Antwort von Markus:
No, I do not have a phone. The support thus far my dealer.
