Frage von UE:
If the DVD into my DVD player is loaded and the menu selection is displayed, I can hear the background music.
But once I start the movie the sound is made!
Only when I am in the DVD player audio menu to switch to PCM, you can hear the sound again!
Why is this so?
Gruss
UE
Antwort von WeiZen:
Moin,
You have made a stencil, which stands for Audio LPCM?
(But then you'd have to "Convert to Disc Template" tab under the Edit Audio have selected)
Antwort von MiXMaster:
Hello,
Thanks again for your past support, you know so good!
So, I've tried a lot a few weeks ago with Power Tools and thereby made many changes, so I you can not answer your question!
I have the synonymous tamper ESTABLISHED that I need to use "Convert to Disc Template" in order to reach its destination.
Only what is, ".. In the disc?
But why does one actually hears only the sound at the menu, as I have described?
I'll try it on my next re-authoring.
Gruss
UE
Antwort von WeiZen:
Moin,
Thank you for the flowers.
Disc template are the presets, presets, with which the DVD will be created. Home>>> project setting bzw.F6 Templates
You can create your own or modify existing ones.
There stands inside the video bit rate and the type of audio (MPEG Audio, LPCM Dolby Digital) and the bit rate. The check mark in the disc .. is jemweils separately for video and audio setting, if mans needs.
NO check mark is set, synonymous nothing is changed, then the project setting refers only to the sections that must be synonymous encoded. So I always video in 8000 would take if you have an MPEG video PT2 made available.
Antwort von UE:
Hello,
in terms of attitudes, the quality is preset with 80%!
Here you can adjust it 100% so as not to deteriorate the quality of the video right?
As an audio format would be synonymous MPEG audio better than LPCM because of Größenbedars, or not?
DVD-Power Tools, you can make through their impact on the "DVDWS.ini" more settings in the encoder setup!
If you do not already know, I can describe it to you.
I think I'm currently dogged by bad luck, which regards the video-stuff. My Canon camcorder displays on the screen after switching on a flashing red icon, that is not listed in the manual. Looks like an arrow on the left and below shows a rectangle that is crossed out. The whole thing is very small. I made a Stillimage synonymous. Get morning contact Canon.
Maybe somebody knows this error or Note!
Gruss
UE
Antwort von WeiZen:
Moin,
True 100% is better.
LPCM should be avoided in connection with a video data rate of 8000th
Then the total bit rate is too high, which lead to Tonaustzern synonymous and jerky picture depends on the player.
Take endweder:
8000 Video and Audio MPEG 2PASS VBR 224
or
8000 Video and Audio AC3 384 VBR 2PASS
Greeting
Ulrich
