Frage von marsteini:
Hello,
currently considering for my new film project so NEN monitor (tube) to operate (simply because he is bigger and the colors are not so how can falsify n TFT by angle). Have at the video diary of the wave seen, I find handy.
Now to the question:
As I see it, because there are two possibilities, the simple (and cheap) to implement:
1. Old Television 30cm diagonal pick up, but everyone just cinch, no S-VHS.
2. CRT monitor (I have geügend rumstehn) and somehow because the S-VHS in VGA format.
What do you this? Panasonic GS230 camcorder is has RCA and S-Video Out. Would the whole later than average camcorder control via + Firwire of Final Cut Pro on meim MacMini use.
What recommended it to me?
Antwort von thos-berlin:
PC CRT monitor, you can safely forget. The necessary signals for the connection are fundamentally different from the normal video.
Otherwise:
(Please do not S-VHS, this is a widespread false name. S-VHS is related to the normal VHS recording format, in which brightness and color are processed separately. There is a connection with separate brightness and color help - S-Video -- connection)
The camcorder is synonymous mE a CVBS signal. This may be of sufficient quality with a monitor (or television) with FBAS connector (RCA or BNC) terms. Even professional monitors have always synonymous FBAS a simple connection. If it be the S-video should be (why?), Then there is suitable adapter with a built-in electronics (not be confused with the adapter for a PC graphics card will be supplied! The do not work as desired).
So short and scarce: The easiest way to take you to the RCA connector s.der Camera and connect it with the Television!
Antwort von marsteini:
Hello,
I thought S-video would be due to the channel separation for better picture quality and would therefore be preferable cinch. In addition, my camcorder to the Av-Out and the Headphones jack in one, so you can not connect both at the same time (mechanically not possible, maybe go but with pass. Adapter, menu, one can only distinguish between "AV Out" and " AV Out / Headphones "switch - I must try).
I think I will now resolve: Can an old television that the rumsteht here. If, however, only the old BNC connectors for video - In. So I think it will be easiest to send me an RF modulator and to get the RCA signal from the device through the antenna cable einzuschleusen. Such a modulator will cost just 10 ¬, it is.
Or is there a BNC / RCA clutch? How do I know that the old TV FBAS s.BNC or not? Was it always so FBAS standardized? Sry but that I know not yet so good ...
