Frage von mauriccce:
Hi,
I had my camer tripod thread at the reingedreht too deep, and now is the camer no longer!
Was tuen I do?
Antwort von MK:
I doubt that you can rotate the tripod socket too deeply into the camera, but the bore has a thread holes behind which is not open.
Antwort von mauriccce:
Yes but it is in the thread, it is turning directly to the rear, however, is that when you have been imprinted
Antwort von Paul*Berlin:
I would not otherwise synonymous exclude that such things happened, for there are the screws so synonymous with no tripod plate.
In any case, you should if you still have warranty on the camera, they bring in the repair, if you have no guarantee on your cam, then you can make it synonymous in the repair, which costs only just then. Although I would not synonymous exclude that the Manufacturer says that the improper dealing with is the action. I know not. Otherwise, if you have no guarantee and want to pay for, you have no choice but to open the Camera and even to try to find the solution to the problem.
Antwort von mauriccce:
Thanks for the response.
I thought it would be better angekugt tripod thread under the thread's the sack I would have then reingedreht or something like that, and then to have the screw reingedreht into the camera.
edit: My Camer a Panasonic hdc SD10 is indeed one can perhaps help.
Antwort von B.DeKid:
Written directly into the OT because it is not appropriate to post here directly
http://forum.slashcam.de/wie-kann-man-nur-so-grob-fahrlassig-with-technik-umgehen-vt80269.html
MfG
B. DeKid
Antwort von Bernd E.:
... Which I would then have reingedreht or something like that, and then to have the screw in the camera ... reingedreht Do you have the tripod screw too deep now rotated in the camera, or not? That would see deutlch yes, if you here the base of the camera would have damaged. If no damage is apparent, the camera work and perhaps again after you have unscrewed the bolt?
Such a use of force by the user by the way covered by any warranty: Because you have been very lucky, have to get the free repair, if in fact a defect has occurred.
Antwort von Modellbahner:
Source: Manual Canon HF200
Antwort von kili:
dat is really hard!
I would assume you do not neglect, I wanted to ask just how is this happening ... for even the end of the thread would have some resistance but have done ...?
but maybe that happens just like that ... just synonymous want to be warned!
Antwort von nicecam:
Refers to
this :
Here comes forth Wonderful, delicious :-)))
Antwort von Jake the rake:
Guarantee is guaranteed gone!
