Frage von Jake the rake:
Hello,
I have a Blackmagic Decklink Card Studio and I tried out a trial basis with all the in and outputs a SonyFX1.
For S-Video and composite input when I get a black border and a strange distortion of the top (see picture).
Does anybody know what the reason might lie and how I can investigate the errors with those that I possibly other devices (I use DV or Component course, if only I can prevent the action of capture).
In the Annex, the Picture, but unfortunately in the wrong aspect ratio.
Antwort von Eastside:
Transfer the signal with FireWire but then you have the edges do not.
Analogue transmission is the case with some devices halt.
The picture is anamorphic SD then you must still set correctly in your editing program.
Antwort von thos-berlin:
For digitizing will ever read on the device instead of the 720 synonymous fewer points (niocht'm quite sure (702 or 704 or so). The disorder previously mentioned edge could be a time code. S.Fernsehes These lie outside the visible range and are at analoggen Common.
Without this "interference" is only the digital recording.
Antwort von Jake the rake:
I will of course always capture the best possible, höchstqualitativste signal. The wrong aspect ratio is only arose because I have not set it on the map.
I just thought there is any possibility of these errors to avoid. The card is installed in a calculator as a mobile capture and editing is designed workstation.
I have searched synonymous in the manual and in the settings of the card if there is irgenwas how you can scale the signal virtually on the fly. Sorry, nothing found.
So you think that lies s.der SonyCam and may vary considerably at different device. I certainly do not think it is the s.der Decklink, would you?
Thanks for your answers in any case!
