Frage von chriss136:since today I have now a Panasonic HD camera and of the progi as above.
Unfortunately, the m2ts files will not be invited because all PROGIS always looking for a tape recorder s.1334. My files are already on the calculator. Now this is not the big problem here.
If I add the files to the time bar, they are higher than the original (1920x1080) and it's missing an entire piece from the bottom of the video. Have tried with the calibration of the PROGIS what to shoot, but it is for a fraction of seconds and then jumps back into this state.
Renders you, then continue missing the lower part.
Meanwhile, I no longer know where I should look for there?
Can I as a good tip NEN give?
Vielen Dank schon mal.
Regards
Christian
Previously, I had video studio, unfortunately, synonymous only supports this tape recorder operated, as well as many other PROGIS synonymous.
Antwort von WeiZen:
Moin,
B button opens the BIN, in the program start but already exists.
There, right mouse button (or the corresponding icon in the toolbar) to open file. Navigate to the folder and highlight all the files you have möchte.Kommen we Settingss to the project, and the correct project template. The Glasgugeln read I have not yet mastered, so I can not call for your needs and generally remain. There are two types of AVCHD, 1440x1080 and 1920x1080.
Change your project settings according to the choices.
Eighth on the frame rate, 60Hz or 50Hz.
Antwort von chriss136:
Moin,
B button opens the BIN, in the program start but already exists.
There, right mouse button (or the corresponding icon in the toolbar) to open file. Navigate to the folder and highlight all the files you have möchte.Kommen we Settingss to the project, and the correct project template. The Glasgugeln read I have not yet mastered, so I can not call for your needs and generally remain. There are two types of AVCHD, 1440x1080 and 1920x1080.
Change your project settings according to the choices.
Eighth on the frame rate, 60Hz or 50Hz. I had thought synonymous turn, the s.den formats is after I restart the PC have made (virus), it worked then synonymous. There is now a new problem, which is here but probably not heard her
Render! It takes all too long, for so little material. 4min 35min render is not acceptable. That went with other PROGIS of Ulead faster. A hardware solution would be better determined in HD!
Antwort von WeiZen:
So I go in less than real time.
Select the clips in the BIN and select convert to CanopusHQ, then take these clips, then go like DV.
My old single-CPU creates at least in the RT.
Antwort von camworks:
it sounds s.als whether the project settings are wrong, especially the resolution ...