Frage von alexandre:
Hello Forum!
I have a thick and very strange problem:
As already described in the topic title is a line on, after I made the film Final Cut Pro 6.0 as a Quicktime (version 7.2.1) was off. The line can be seen synonymous during the cutting, but only while playing - once you break it pushes away ...
Again to cut material that can not indent from the edge of the starting material, since this in Final Cut Pro is already bigger scale and you can not see the actual edge.
I have been synonymous with different pixel formats, and so next rumprobiert, but nothing!
Has someone an idea! I have to necessarily hinbekommen - it is important!
Would a screenshot help?
Thank you in advance
Antwort von PowerMac:
Screenshot please.
Update to Final Cut Pro 6.0.3 and newer Quicktime do.
Antwort von alexandre:
... here the screen:
Antwort von Markus:
As already described in the topic title is a line on, after I made the film Final Cut Pro 6.0 as a Quicktime (version 7.2.1) was off. I remember s.einen similar case, we are not so long ago had. A trimming of the material to a line or Drüben Put a black strip had nothing, because the green line in the exported material always reappeared. (Perhaps this is in your case so different?)
If I only knew what Suchwort with the then discussion can be found and whether it could ultimately be a solution there? ...
Antwort von PowerMac:
I slide to the outdated version of Quicktime or graphics card can s.der lie. Quicktime 7.4.5 and Final Cut Pro 6.0.3 currently. Also, the Pro Application Updates make. Just everything in the software update appears.
Antwort von alexandre:
Yes exactly! A circumcision did not work.
So just to update everything, what goes and then try it again ...
... I say about it if it went well!
Greetings and Thanks
Antwort von alexandre:
... no change after the updates!
still any ideas? it can not be that because you can not do anything!
gruß
Antwort von PowerMac:
Do you have an external monitor?
Antwort von alexandre:
no I did not - I could possibly connect a second tft.
but nothing that would bring it? possibly at times dv off on a TV set and view ...? what do you think?
regards
Antwort von domain:
I'm not a Final Cut Pro Trimmer but synonymous in the Windows world and with different NL-HDV editors were in the lower 8 green or gray lines often times a problem. If allegedly s.veralteten encoders.
If possible, try before Rausrendern the vertical Resolutionum exactly the faulty lines in their numbers to increase.
In my case it is 1088 instead of 1080 lines and that was the problem was temporarily resolved.
Antwort von alexandre:
Thanks for the tip I will give it a try!
gruß
