Frage von tsaG:
Hi dear Slashcam
I will next WE need my firewire port. I have a FWKarte it but how can I without FWGerät test if that works? I need the FWPort to capture and have very little time, so a new spontaneous FWKarte buy bad is possible.
No hard drive of me has a FWAnschluß, effects on the network by looking for programs, but there's nothing clever here. Also on the device manager I have found nothing. FW USB is not displayed, so these fears. Hat jmd an idea?
Antwort von baststar:
look in the device manager (Control Panel) and look to see if the IEEE 1394 controller is installed, so no exclamation mark or cross in front of the hardware is. If not, then the firewire card is properly installed and work should be synonymous. Could perhaps the manufacturer of the firewire card the latest drivers to download and install, if it is an extra card is built. otherwise the latest motherboard drivers from the motherboard manufacturer to install ...
Antwort von dirk.thiele:
IEEE 1394 Bus host controllers
l
l --- VIA OHCI-compliant IEEE 1394 host controller
l --- VIA OHCI-compliant IEEE 1394 host controller
no exclamation point, no yellow warnzeugs
Antwort von baststar:
it should be synonymous work. firewire anyway makes little probleme ... So I had somehow not yet ...
Antwort von dirk.thiele:
God's word in your ear ...
Antwort von Markus:
I need the FWPort to capture and have very little time ... If the compilation of reliable and no failures must be tolerated (may), then it is necessarily a previous test run is required (mandatory, not optional!) And is involved with all devices: camcorder, cables, computers. Even so often failed to connect s.einem inferior cable (see synonymous
Wenn Firewire nicht richtig funktioniert).
Wenn Firewire nicht richtig funktioniert).
Wenn Firewire nicht richtig funktioniert).
