Frage von katau:
Hi,
I will s.meine connect the receiver Sennheiser EK 100 G3 SonyAX2000. The connection is via a 3-pin XLR-Male. Camera side, you can choose whether this input line, mic or mic +48 V to serve. I place on "Line", I get de facto no input signal. Now is the Sennheiser operating the radio receiver, however, that this s.den "Line port" of the camcorder is connected.
Does anyone have experience with it? Can I, without doing any damage, the AX2000 s.der input to "Mic" - then I get that is a very ordinary input signal?
Antwort von rush:
I have the g2 ek100 s.meiner panasonic camera synonymous of MIC-level run .. no problems, everything perfectly.
The microphone level is usually significantly lower than the LINE level so you need not worry because you just do what is broken. 48V, however, remain disabled!
About LINE synonymous but it should work .. if necessary, you have the EK100 adjust the settings.
Antwort von newsart:
You can s.Empfänger the strength of the line signal set and adjust the input sensitivity s.vielen cameras and thus receiver and Camera together. But of course you can simply put the camera on synonymous Mic, unless the signal sounds distorted. We do synonymous thing, because then you can not forget the Changing who one time is quick with a Micro directly by cable to the camera. Greetings, Carsten
Antwort von katau:
Thanks, your answers to calm me.
In "Line" I get that is not nearly the same input signal as to "Mic", even if I s.Empfänger at "Line" the AF-out put value to +12 dB and the Rec Level s.Camcorders to the top turn .
I assume the same is true when I connect to the beneficiary s.den camcorder, but s.einen Field recorder, such as the M10 or the zoom-SonyPCM H4n - is that so?
Antwort von mbwkrause:
You must own the potentiometer s.der Camera revving always, if you use line-in, or you regularly down the incoming signal. In the line-in, the built-in microphone preamp bypassed the Camera, the incoming signal is passed directly. Or rather the other way around: The radio receiver takes over the role of the preamplifier alone. This is good if he can make it, that is enough noise-free gain (amplification) returns. Otherwise you can switch on Mic-in, which then has the disadvantage that you have two micro-Vertsärker in series, may increase the noise twice.
Antwort von katau:
thanks for the advice.
Perhaps `s because synonymous s.verwendeten Microphone, that so little goes inside. Get the test again with another Micro.
