Frage von Foffel:
First Addendum to do better than:
The following of my problems have been described by trial and error than software bug out. In this case it was Cyberlink Director, at the capture of HD material is always a whistle. I still have to look next if the only problem. I hope so.
Here begins the original thread:
Hi folks,
I have a mixer via the microphone input s.meine HV20 connected. In the mixer, a dynamic microphone. So far so good.
I have the input menu via abgedämpft regulated and everything nice, that is not overridden or too quiet. The input volume, I have dealt manual, not with the automatic.
In DV mode, the sound is good.
In HD mode, an awful quiet, but clearly audible whistles added.
Very annoying and disturbing.
This makes itself felt only when the material I've played on.
If I IM camcorder via Headphones durchhöre is not there, perhaps because of the headphone output synonymous garnicht as a volume-how. No clue.
My question:
Is it synonymous with you?
Antwort von domain:
After my experience can be 3.5 mm input jack for external microphones indoors practically forgotten. Any electromagnetic disturbance is almost always within reach, so that it induced interference and extraneous noise to come. Works in my environment in any case only in the open pretty good.
If you are a Tonfreak are, then just XLR inputs for camcorders into question.
Merwürdig is that the noise in DV mode, not to be heard.
Antwort von Foffel:
After my experience can be 3.5 mm input jack for external microphones indoors practically forgotten. Any electromagnetic disturbance is almost always within reach, so that it induced interference and extraneous noise to come. Works in my environment in any case only in the open pretty good.
If you are a Tonfreak are, then just XLR inputs for camcorders into question.
Merwürdig is that the noise in DV mode, not to be heard. So the problem occurs only when dubbing with the Firewire cable. And since these data are digital, no noise is permanent. I think.
So if I sound in the HV20 listening, everything is ok.
Antwort von domain:
As you say yourself, you can not be additional noise from the dubbing via Firewire come. They are already in the original thing.
You say, thou hast not the sound in DV mode. Is this a special recording HDV as DV or off to another recording?
That would explain a lot.
Antwort von Foffel:
Sunday
The cause is found.
The high Fiepen comes when during the recording in HD
Mode s.die HV20 Firewire cable is connected!
I got it in the HV25 mode as synonymous in HV Normal Mode.
Everytime the Fiepsen.
It happened this way: I wanted to be equal to the signal from the HV20 to my
Save Calculator. So was the Firewire cable logically during the recording s.der HV20.
Synonymous But when you look at the tape recording, the Fiepsen,
if the Firewire cable s.der HV20 still hangs!
That is of course a pity. Because that means that you never HV20
Live transmission device will be able to use. Always will be this
Fiepsen have.
You can somewhat reduce Fiepsen by the
Mic attenuation switch and the input level saraykaribu very far
sets down and then the incoming signal (s.mixer) louder
makes. But a very clear sound you get is not.
A pity really, because I am so at home recording studio is not directly
on the calculator can store but always a detour on the
Tape must go.
Naja. At least I know now what it is.
It remains now only the question whether perhaps a defect or my HV20
a Firewire cable is inferior.
Would be nice if the times when someone is synonymous tried.
Antwort von ruessel:
Folding times on the LCD screen, it is synonymous with the rest fiepen.
Antwort von Foffel:
Folding times on the LCD screen, it is synonymous with the rest fiepen. No.. I've tried out immediately. This changes nothing.
Antwort von Foffel:
As you say yourself, you can not be additional noise from the dubbing via Firewire come. They are already in the original thing.
You say, thou hast not the sound in DV mode. Is this a special recording HDV as DV or off to another recording?
That would explain a lot. Oh, you disgrace!
It's crazy.
When I recorded the video in Media Player instead of the video program (Cyberlink Director) is the Fiepsen gone.
What is it now again!
I is my beautiful!
Antwort von kkutte:
Well, then certainly not with Your Camera or Micro, but software problems.
kkutte
Antwort von Foffel:
Well, then certainly not with Your Camera or Micro, but software problems.
kkutte Yes. I use the program only to capture, so I always synonymous in the program viewed the material.
That there is no such problems, is crass. Since you have come so erstmal drauf.
