Frage von Harry Potter:
Hi folks,
after a long search (synonymous here in the forum), I try my luck with you.
For 3D's tracking information will I need to resize my CCD SONY DCR HC35E (Height and width in mm).
If your data on the focal min-max synonymous nor bag should have, I am not evil. I had the time found ... But as always, not down.
Thank times in advance! (The hope dies last :-))
Martin
Antwort von flipmo:
CCD: 1 / 6 "
Optics: Zoom lens - 2.3 mm - 46 mm - f/1.8-3.1
Note: you buy what is eiteres;)
Antwort von Harry Potter:
Hey,
na it was so fast ...
1 / 6 "means in mm? If the page synonymous ratio of the CCD 4 / 3 is that I can if necessary synonymous myself. Isses the 4 / 3? But perhaps thou hast ja ne same formula or data. I ask simple, gelle?
Well what Eiteres buy Speed ... I tell my wife always synonymous. And you said the movies of the kids are good but ... ME: "Yes in the garden in the sunlight on a PAL television !!!!!!) woe when it gets dark ...."
Defines the thanks in the drawer to the others thank you!
Martin
Antwort von flipmo:
1 / 6 "means in mm? 4:23 mm
http://www.convertworld.com/de
Antwort von Harry Potter:
Thank you!
so I said of course not!
mm Inch krieg I thank God still out 8-).
Just once more at WIKIPEDIA vorbeigeschaut. Since when is 1 / 6 inch CCD, the speech of a net active image area of 3mm diagonal, since
specifying the size of 1 / 6 "CCD s.alten analog tubes oriented and there were
is a gross and net difference.
So I come then to the brain and calculator to take an active (net) area of the image 1 / 6 "CCD of 2.4 x1, 8mm.
I need as I have said yes, the Width and Height of the active CCD area. In conjunction with the focal, the 3D tracker Moving a perfect match.
Maybe Can someone from my tray "computing arts" confirm or verify?
http://de.wikipedia.org/wiki/Charge-coupled_Device
THANK YOU!
Antwort von Bernd E.:
... Since when is 1 / 6 inch CCD, the speech of a net active image area of 3mm diagonal, as an indication of the size 1 / 6 "CCD s.alten analog tubes oriented ... Just as it is: The simple conversion of inches in millimeters therefore delivers incorrect results. In fact, the so-called "1/6-Inch" sensor the HC35 a diagonal of three millimeters. This information would be very fast in the manual had to find ;-)
Gruß Bernd E.
Antwort von flipmo:
Hmmm,
Ash on my head.
But I think there have been searched and not found it.
But now a happy iss.
S.alle Thank you!
