Frage von Alpinist:
Hello,
somewhere there is a ready-made lens hood for the HC3?
Or there are (currently) only the
Antwort von Axel:
Salut,
The sun visor shown in the link is good for a bit, but not much. If your Alias | Wavefront Maya, a reference to the recordings in which you want to use the camera, I recommend you first, a polarizer. This is the same as synonymous decent ND filter, so the camera has built probably synonymous. Secondly, a usual usual sun visor like these rubber things just lateral stray from. Diagonal Picture to incident light, but not only in the Backlighting dreaded
lens flare effect, it irritates the synonymous Metering and leads indirectly to kontrastschwächeren shots. The Hama-premeditation shown is rectangular but its still in good shape feintunen, by going forward a mask permanently attached, which really only the picture release. Optimal would be - obviously black - mask a little too small to make s.den and edges with a file to work patiently with the lens up an bevelled "Shaft" should arise, so that is the outer edge is sharp (previously test whether Viewfinder your actual borders of the picture shows otherwise prefer to use an external monitor).
Seeing is believing. Geh mal so on the slopes. The images are crisp, as she herself in hours of Postpro-Filterei could not be better - which it will become obsolete.
Antwort von Alpinist:
The sun visor shown in the link is good for a bit, but not much. Schade
If your Alias | Wavefront Maya, a reference to the recordings in which you want to use the camera, I recommend you first, a polarizer. This is the same as synonymous decent ND filter, so the camera has built probably synonymous. I polarizer, ND filter, a built-HC3 has not. However, the polarizer, I do not always need it and therefore I Gegenlicht-/Streulichblende to 'fast-times-without-much-screw-film-to-can'
The Hama-premeditation shown is rectangular but its still in good shape feintunen, by going forward a mask permanently attached, which really only the picture release. Optimal would be - obviously black - mask a little too small to make s.den and edges with a file to work patiently with the lens up an bevelled "Shaft" should arise, so that is the outer edge is sharp (previously test whether Viewfinder your actual borders of the picture shows otherwise prefer to use an external monitor). That I've already considered synonymous, but my time is synonymous limited ;-)
Then I look at the parts stores in the times to show (unless they know a better solution) and try out what the delta between the rectangle and the image really is. With a little luck, it is already above and below black bars anzukleben ...
Thanks + greetings
--
http://www.alpinisten.info/
http://www.gipfelsammler.de/
