Frage von SHausW:
Hello, I have the following problem.
My DVD is a chapter selection with 15 chapters have. Now I have the problem that the individual buttons are not with the high-Down keys on the remote control are adjust. At the remote menu (only start film and chapter selection) and it goes with the number keys and the mouse s.PC I can choose the chapters. Where is because the crux of the matter?
Am I to understand words? Danke schon mal in advance.
Antwort von Andreas Pokladek:
Hello, I have the following problem.
My DVD is a chapter selection with 15 chapters have. Now I have the problem that the individual buttons are not with the high-Down keys on the remote control are adjust. At the remote menu (only start film and chapter selection) and it goes with the number keys and the mouse s.PC I can choose the chapters. Where is because the crux of the matter?
Am I to understand words? Danke schon mal in advance.
Hello SHausW,
I understand this correctly that you have the buttons by which you can not navigate s.PC very well with the mouse can activate? My first guess was that you simply have forgotten the buttons to be defined as the buttons (right mouse button - Button object to convert).
Another tip is to use the button sequence in the show to let Menuvorschau (small button at the bottom left s.der Menuvorschau) because you can go on the behavior during the navigation in detail to determine (one schematic circle with four small arrows around it ... ).
Otherwise ... otherwise your menu works? Look in the Menueigenschaften (range) to: Perhaps you have one menu with the "automatic button sequence" is activated, the second does not ...?
I would, however, the manual button sequence always defined by the program is given two buttons s.mehr as illogical (I think). Then you need to disable Atomatik course.
It helps nothing: Encore is great, silly, but what are the details, I always check everything sytematisch two to three times through, especially for complex or nested menus and playlists ... Everything must be right.
For you: either activate automatic sequence (in the Properties palette menu), or disable and then on the small button at the bottom left s.der Menuvorschau can show the sequence and define themselves.
Good luck!
Greetings from Dusseldorf, Andreas.
Antwort von JMitch:
Thank you for the detailed answer. I will search on the times.
Antwort von JMitch:
Another tip is to use the button sequence in the show to let Menuvorschau (small button at the bottom left s.der Menuvorschau) because you can go on the behavior during the navigation in detail to determine (one schematic circle with four small arrows around it ... ).
I would, however, the manual button sequence always defined by the program is given two buttons s.mehr as illogical (I think). Then you need to disable Atomatik course.
Thanks Andrew, just as was the error. Now it works as it should. Here, you helped.
Many greetings
SHausW
